Department of Materials Science and Engineering, and Research Institute of Advanced Materials, Seoul National University 1 , Seoul 08826, Republic of Korea
Auto-generated profile, based on publicly available information
Euijoon Yoon
Department of Materials Science and Engineering, and Research Institute of Advanced Materials, Seoul National University 1 , Seoul 08826, Republic of Korea
We demonstrated AlGaN-based deep ultraviolet light-emitting diodes (DUV LEDs) with periodic air-voids-incorporated nanoscale patterns enabled by nanosphere lithography and epitaxial lateral overgrowth (ELO) on a 4-in. sapphire substrate. The nanoscale ELO improved the crystal quality of overgrown epitaxial layers at a relatively low growth temperature of 1050 °C and at small coalescence thickness less than 2 μm. The light output power of the DUV LED was enhanced significantly by 67% at an injection current of 20 mA. We attribute such a remarkable enhancement to the formation of embedded periodic air voids which cause simultaneous improvements in the crystal quality of epitaxial layers by ELO and light extraction efficiency enabled by breaking the predominant in-plane guided propagation of DUV photons.
We have investigated electrical characteristics of leakage current paths in n-GaN layer grown by metal-organic chemical vapor deposition with conductive-atomic force microscopy (C-AFM). The C-AFM mapping shows two kinds of leakage current paths existing in the n-GaN layer: open-core dislocation and pure screw dislocation. From the localized I-V curves measured by C-AFM, we confirmed that the open-core screw dislocation shows more significant leakage current. We explained these results in terms of a modified Schottky band model based on donor states formed by oxygen segregation at the {10−10} sidewall of the open-core screw dislocation.
The reconstruction and evaporation at graphene nanoribbon (GNR) edges are investigated by tight-binding molecular-dynamics simulations and ab initio calculations. It is observed that reconstruction through the formation of pentagon-heptagon pairs can take place quickly along the zigzag edge and it is energetically favorable. At very high temperatures, the armchair edge is found to change into a zigzag edge structure, which further accelerates the evaporation of carbon atoms and leads to the formation of carbon linear chains. The evaporation of carbon atoms from both the zigzag and armchair edges is preceded by the formation of heptagon rings, which serve as a gateway for carbon atoms to escape. In the simulation for a GNR armchair-zigzag-armchair junction, carbon atoms are evaporated row by row from the outermost row of the zigzag edge while the armchair edge remains nearly intact. These results can be applied to nanoelectronic devices fabrication through the temperature-controlled edge structure of GNR.
In this study, multicolor photodetectors (PDs) fabricated by using bulk p-i-n-based visible GaAs and near-infrared InGaAs structures were monolithically integrated through a high-throughput epitaxial lift-off (ELO) process. To perform multicolor detection in integrated structures, GaAs PDs were transferred onto InGaAs PDs by using a Y2O3 bonding layer to simultaneously detect visible and near-infrared photons and minimize the optical loss. As a result, it was found that the GaAs top PD and InGaAs bottom PD were vertically aligned without tilting in x-ray diffraction (XRD) measurement. A negligible change in the dark currents for each PD was observed in comparison with reference PDs through electrical characterization. Furthermore, through optical measurements and simulation, photoresponses were clearly revealed in the visible and near-infrared band for the material’s absorption region, respectively. Finally, we demonstrated the simultaneous multicolor detection of the visible and near-infrared region,which implies individual access to each PD without mutual interference. These results are a significant improvement for the fabrication of multicolor PDs that enables the formation of bulk-based multicolor PDs on a single substrate with a high pixel density and nearly perfect vertical alignment for high-resolution multicolor imaging.