The gas-phase etching of SiO2 was examined using HF and methanol vapor at temperatures below 0 °C and at low pressure. The etching rate of SiO2 increased with decreasing temperature and showed a maximum around –30 °C. The obtained etching rate was a maximum of 40 nm min−1 at plasma-enhanced chemical vapor deposition SiO2. The etching rate of SiN examined for comparison was more than ten times smaller than that of SiO2 under the same condition. As a result, the etching selectivity of SiO2 to SiN was found to be over 20 at –40 °C. When utilizing a low temperature of less than –30 °C, gas-phase etching of SiO2 showing a high etching rate and selectivity was achieved.
1 January 2006 in Journal of Photopolymer Science and Technology
We have examined alicyclic polymers with a (gamma) -hydroxy acid structure in order to investigate the properties of (gamma) -hydroxy acid and (gamma) -lactone as function groups of ArF negative resist materials. From the viewpoint of transparency and dry-etching resistance, (gamma) -hydroxy acid and (gamma) -lactone structure were found to be suitable for ArF negative resists materials. Surprisingly, the reactivity of the acid-catalyzed reaction of (gamma) -hydroxy acid is affected by the polymer structure. Using ArF excimer laser stepper, 0.20-micrometers line-and-space patterns without micro-swelling distortion were obtained from a negative resist consisting of alicyclic polymer with the (gamma) - hydroxy acid structure and a photoacid generator. Distortion was avoided because the number of carboxyl groups decreased drastically in the exposed area by the acid-catalyzed intramolecular esterification of (gamma) -hydroxy acid to (gamma) -lactone. As a result, (gamma) -hydroxy acid and (gamma) -lactone structure were found to be suitable function groups for ArF negative resist materials.
3 June 2024 in Japanese Journal of Applied Physics
Isotropic gas-phase etching of SiO2 was examined using HF and methanol vapor while changing the pressure from 300 to 900 Pa. The temperature dependence of the etching rate of SiO2 showed a broad maximum around –30 °C, and the rate increased with increasing pressure. The etching rate of plasma-enhanced CVD (PE-CVD) SiO2 was more than 60 nm min−1 at 900 Pa and –30 °C. When the pressure was increased from 300 to 900 Pa, the temperature range that indicates SiO2 etching was shifted to a higher temperature. The etching of SiO2, which did not proceed at 300 Pa, was found to proceed even at 0 °C at 900 Pa. The etching rate of PE-CVD SiN was also found to increase slightly with pressure. At the higher pressure of 900 Pa, the formation of ammonium hexafluorosilicate, which is a by-product of SiN, was found to increase. As a result, a high selectivity of more than 20 was obtained at a lower pressure of less than 600 Pa and a lower temperature of less than –40 °C.