1 February 2002 in Nature
11 March 2007 in Philosophical Magazine
The dislocation density tensor has been an important variable in the theoretical characterization of dislocations in deformed crystals since its introduction over 5 decades ago. However, the non-destructive, three-dimensional (3D) measurements of lattice rotations and elastic strain needed to determine dislocation density tensors with micron spatial resolution over mesoscopic length scales have until now not been available. We have used 3D X-ray microscopy with sub-micron point-to-point spatial resolution to demonstrate 3D, spatially resolved measurements of the dislocation density tensor in elastically and plastically deformed silicon single crystal plates. Measurements were made of the dislocation density tensor along a line in a ∼35 µm thick silicon plate that was bent (elastically) to a 5.42 mm radius of curvature at room temperature, and in a similar sample deformed plastically by annealing to 700°C under bending stress. We discuss the theoretical background for the dislocation density tensor with respect to lattice rotation and elastic strain, we describe the X-ray microscopy technique used to make non-destructive measurement of local rotations and elastic strains with sub-micron resolution in 3D, and we discuss the analysis procedures for extracting dislocation tensors on mesoscopic length scales.
1 April 2008 in Journal of Engineering Materials and Technology
Three-dimensional (3D) X-ray microscopy with submicron resolution has been used to make spatially resolved measurements of lattice curvature and elastic strain over two-dimensional slices in thin deformed Si plates. The techniques and capabilities associated with white-beam 3D X-ray microscopy are discussed, and both theoretical and experimental considerations associated with the measurement of Nye dislocation density tensors in deformed materials are presented. The ability to determine the local geometrically necessary dislocation (GND) density in the form of a dislocation density tensor, with micron spatial resolution over mesoscopic length scales, is demonstrated. Results are shown for the special case of an elastically bent (dislocation free) thin Si plate and for a similar thin Si plate that was bent plastically, above the brittle-to-ductile transition temperature, to introduce dislocations. Within the uncertainties of the measurements, the known result that GND density is zero for elastic bending is obtained, and well-defined GND distributions are observed in the plastically deformed Si plate. The direct and absolute connection between experimental measurements of GND density and multiscale modeling and computer simulations of deformation microstructures is discussed to highlight the importance of submicron-resolution 3D X-ray microscopy for mesoscale characterization of material defects and to achieve a fundamental understanding of deformation in ductile materials.
24 April 2003 in Physica Status Solidi (b)