The ability to use common computational thermodynamic and kinetic tools to study the microstructure evolution in Inconel 625 (IN625) manufactured using the additive manufacturing (AM) technique of laser powder-bed fusion is evaluated. Solidification simulations indicate that laser melting and re-melting during printing produce highly segregated interdendritic regions. Precipitation simulations for different degrees of segregation show that the larger the segregation, i.e. , the richer the interdendritic regions are in Nb and Mo, the faster the δ-phase (Ni 3 Nb) precipitation. This is in accordance with the accelerated δ precipitation observed experimentally during post-build heat treatments of AM IN625 compared to wrought IN625. The δ-phase may be undesirable since it can lead to detrimental effects on the mechanical properties. The results are presented in the form of a TTT diagram and agreement between the simulated diagram and the experimental TTT diagram demonstrate how these computational tools can be used to guide and optimize post-build treatments of AM materials.
10 May 2018 in Metallurgical and Materials Transactions A
This research evaluated the kinetics of δ-phase growth in laser powder bed additively-manufactured (AM) Inconel 625 during post-build stress-relief heat treatments. The temperatures ranged between 650 °C and 1050 °C, and the times from 0.25 to 168 hours. The presence of δ-phase was verified for each temperature/time combination through multiple techniques. A conventional time-temperature-transformation diagram was constructed from the time-temperature data. Comparison to the growth in wrought IN625 with a similar nominal composition revealed that δ-phase formation occurred at least two orders of magnitude faster in the AM IN625. The results of this study also revealed that the segregated microstructure in the as-built condition has a strong influence on the kinetics of δ-phase formation in AM IN625 as compared to a homogenized material. Since control of the δ-phase growth is essential for reliable prediction of the performance of IN625 components in service, avoiding heat treatments that promote the formation of δ-phase in AM components that are not homogenized is highly recommended. This will be particularly true at elevated temperatures where the microstructural stability and the consistency of mechanical properties are more likely to be affected by the presence of δ-phase.
The microstructure of a hot-work tool steel additively manufactured using laser powder-bed fusion (L-PBF), and its response to post heat treatment, is studied in detail by microstructure characterization and computational thermodynamics and kinetics. The high solidification and cooling rates during the L-PBF process lead to suppression of δ-ferrite and instead solidification of an austenite phase directly containing a cellular substructure where the alloying elements have segregated to the inter-cellular regions and where solidification carbides have formed in the cell junctions. The austenite is then partly decomposed into martensite at lower temperatures. The micro-segregation can be predicted by reducing the complex solidification behavior to a diffusion problem in one dimension enabling detailed comparisons with the measured segregation profiles quantified at a nanometer scale. Martensite start temperature (Ms) calculations along the spatially varying composition show that the Ms temperature decreases in the inter-cellular regions where austenite is observed. The network of austenite in the as-built microstructure can be understood from the combined influence of the composition dependence of the Ms temperature in relation to the build plate temperature and the mechanical stabilization of the small-sized austenite regions. This work demonstrates the power of computational tools based on computational thermodynamics and kinetics for designing tool steels for additive manufacturing by predictions of the steel’s response to the L-PBF process and post heat treatments.