15 April 2021 in Microsystems & Nanoengineering
Periodic microscale array structures play an important role in diverse applications involving photonic crystals and diffraction gratings. A polarized holographic lithography system is proposed for patterning high-uniformity microscale two-dimensional crossed-grating structures with periodic tunability. Orthogonal two-axis Lloyd’s mirror interference and polarization modulation produce three sub-beams, enabling the formation of two-dimensional crossed-grating patterns with wavelength-comparable periods by a single exposure. The two-dimensional-pattern period can also be flexibly tuned by adjusting the interferometer spatial positioning. Polarization states of three sub-beams, defining the uniformity of the interference fringes, are modulated at their initial-polarization states based on a strict full polarization tracing model in a three-dimensional space. A polarization modulation model is established considering two conditions of eliminating the unexpected interference and providing the desired identical interference intensities. The proposed system is a promising approach for fabricating high-uniformity two-dimensional crossed gratings with a relatively large grating period range of 500–1500 nm. Moreover, our rapid and stable approach for patterning period-tunable two-dimensional-array microstructures with high uniformity could be applicable to other multibeam interference lithography techniques.
26 September 2016 in Journal of Microelectromechanical Systems
This paper reports the novel design, fabrication, and testing of a chip-level comb-drive XYZ-microstage that produces large displacements into x-, y-, and z-directions. The main parts of the XYZ-microstage, consisting of a combdrive XY-microstage for in-plane actuations, two comb-drive Z-actuators for out-of-plane actuation, and a bottom silicon base substrate, are assembled together based on chiplevel microassembly technology. The Z-actuators are vertically mounted on the grooves of silicon base substrate and kept in place by the support base block. Then, the XY-microstage is mounted onto the Z-actuators. The small pillars supported by mechanical springs in Z-actuator chips are inserted into the holes of XY-microstage. The conductive glue is used to hold the assembled structure of XYZ-microstage after curing, and also to achieve the electrical connections between the pillars in Z-actuators and the outer driving source of the XY-microstage. Therefore, all the bonded wires can be arranged together on Z-actuator chips, for the application of actuation voltages. It is demonstrated that the assembled comb-drive XYZ-microstage can achieve large displacements of 25.2 μm in x-direction, 20.4 μm in y-direction, and 58.5 μm in z-direction.