Direct air capture (DAC) can provide an impactful, engineered approach to combat climate change by removing carbon dioxide (CO2) from the air. However, to meet climate goals, DAC needs to be scaled at a rapid rate. Current DAC approaches use engineered contactors filled with chemicals to repeatedly capture CO2 from the air and release high purity CO2 that can be stored or otherwise used. This review article focuses on two distinctive, commercial DAC processes to bind with CO2: solid sorbents and liquid solvents. We discuss the properties of solvents and sorbents, including mass transfer, heat transfer and chemical kinetics, as well as how these properties influence the design and cost of the DAC process. Further, we provide a novel overview of the considerations for deploying these DAC technologies, including concepts for learning-by-doing that may drive down costs and material requirements for scaling up DAC technologies.
To avoid dangerous climate change, new technologies must remove billions of tonnes of CO2 from the atmosphere every year by mid-century. Here we detail a land-based enhanced weathering cycle utilizing magnesite (MgCO3) feedstock to repeatedly capture CO2 from the atmosphere. In this process, MgCO3 is calcined, producing caustic magnesia (MgO) and high-purity CO2. This MgO is spread over land to carbonate for a year by reacting with atmospheric CO2. The carbonate minerals are then recollected and re-calcined. The reproduced MgO is spread over land to carbonate again. We show this process could cost approximately $46–159 tCO2−1 net removed from the atmosphere, considering grid and solar electricity without post-processing costs. This technology may achieve lower costs than projections for more extensively engineered Direct Air Capture methods. It has the scalable potential to remove at least 2–3 GtCO2 year−1, and may make a meaningful contribution to mitigating climate change.
3 December 2019 in Greenhouse Gases: Science and Technology
The iron and steel industry has played a large part in global industrialization and now accounts for about 7% of global anthropogenic CO2 emissions. As thorough progress has already been made in minimizing the carbon footprint through process optimization efficiency increases, further emissions reductions could be achieved through carbon capture and sequestration (CCS). In an analysis of existing production capacity around the globe, most production facilities will likely continue to run in the coming decades, presenting an opportunity to install retrofit CCS technologies onto existing plants, like absorption and oxyfuel top gas recycling. More advanced CCS technologies such as hydrogen direct reduction and smelting reduction should be installed within the upcoming production plants being constructed. Current international initiatives like ULCOS and HYBRIT, evolving government policies and incentives, and pilot projects are helping to improve process economics and shedding light on industrial viability.