Fanbao Meng

Fanbao Meng

Auto-generated profile, based on publicly available information

Fanbao Meng

Guangdong Provincial Key Lab of Geological Processes and Mineral Resources School of Earth Sciences and Engineering Sun Yat‐sen University Guangzhou China

Research Focus & Metrics

Academic Career Length

12Years (2015-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 September 2015 in Petroleum Science
Verified
Journal Article
Open access
PDF file
HGHong-Kui Ge
Hong-Kui Ge
Liu YangLiu Yang
Liu Yang
YSYing-Hao Shen
Ying-Hao Shen
KRKai Ren
Kai Ren
FMFan-Bao Meng
Fan-Bao Meng
SWShan Wu
Shan Wu
Spontaneous imbibition of water-based fracturing fluids into the shale matrix is considered to be the main mechanism responsible for the high volume of water loss during the flowback period. Understanding the matrix imbibition capacity and rate helps to determine the fracturing fluid volume, optimize the flowback design, and to analyze the influences on the production of shale gas. Imbibition experiments were conducted on shale samples from the Sichuan Basin, and some tight sandstone samples from the Ordos Basin. Tight volcanic samples from the Songliao Basin were also investigated for comparison. The effects of porosity, clay minerals, surfactants, and KCl solutions on the matrix imbibition capacity and rate were systematically investigated. The results show that the imbibition characteristic of tight rocks can be characterized by the imbibition curve shape, the imbibition capacity, the imbibition rate, and the diffusion rate. The driving forces of water imbibition are the capillary pressure and the clay absorption force. For the tight rocks with low clay contents, the imbibition capacity and rate are positively correlated with the porosity. For tight rocks with high clay content, the type and content of clay minerals are the most important factors affecting the imbibition capacity. The imbibed water volume normalized by the porosity increases with an increasing total clay content. Smectite and illite/smectite tend to greatly enhance the water imbibition capacity. Furthermore, clay-rich tight rocks can imbibe a volume of water greater than their measured pore volume. The average ratio of the imbibed water volume to the pore volume is approximately 1.1 in the Niutitang shale, 1.9 in the Lujiaping shale, 2.8 in the Longmaxi shale, and 4.0 in the Yingcheng volcanic rock, and this ratio can be regarded as a parameter that indicates the influence of clay. In addition, surfactants can change the imbibition capacity due to alteration of the capillary pressure and wettability. A 10 wt% KCl solution can inhibit clay absorption to reduce the imbibition capacity.

1 March 2015 in Journal of Natural Gas Science and Engineering
Verified
Journal Article
Closed access
DWDaobing Wang
Daobing Wang
HGHongkui Ge
Hongkui Ge
XWXiaoqiong Wang
Xiaoqiong Wang
JWJianbo Wang
Jianbo Wang
FMFanbao Meng
Fanbao Meng
PHPeng Han
Peng Han

1 May 2017 in Journal of Natural Gas Science and Engineering
Verified
Journal Article
Closed access
SWShan Wu
Shan Wu
HGHongkui Ge
Hongkui Ge
XWXiaoqiong Wang
Xiaoqiong Wang
FMFanbao Meng
Fanbao Meng

24 January 2019 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
FMFanbao Meng
Fanbao Meng
PBPatrick Baud
Patrick Baud
HGHongkui Ge
Hongkui Ge
TWTeng‐Fong Wong
Teng‐Fong Wong
The evolution of permeability and its effective stress behavior is related to inelastic deformation and failure mode. This was systematically investigated in Indiana and Purbeck limestones with porosities of 16% and 14%, respectively. High‐pressure compression tests were conducted at room temperature on water‐saturated samples. At relatively high confinement shear‐enhanced compaction was observed to initiate at a critical stress, accompanied by significant permeability reduction of up to a factor of ~3. Overall, the permeability reduction due to inelastic compaction in our limestones is smaller than that observed in sandstones. At relatively low confinement, dilatant failure was observed, which was accompanied by a decrease and increase of permeability in Indiana and Purbeck limestones, respectively. There seems to be a trend for the correlation between porosity and permeability changes to switch from positive to negative with increasing porosity. The void space of both limestones has significant proportions of macropores and micropores. The effective stress behavior of such a limestone with dual porosity has been documented to be different from the prediction for a microscopically homogeneous assemblage, in that its effective stress coefficients for permeability and pore volume change may attain values significantly >1. In contrast, our investigation of damaged samples consistently showed effective stress coefficients for both permeability and pore volume change with values <1. This suggests that the behavior in the damaged samples is akin to that of a microscopically homogeneous assemblage, possibly due to pervasive collapse of macropores that would effectively homogenize the initially bimodal pore size distribution.

14 June 2018 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
YWYing Wang
Ying Wang
FMFanbao Meng
Fanbao Meng
XWXiaoqiong Wang
Xiaoqiong Wang
PBPatrick Baud
Patrick Baud
TWTeng‐Fong Wong
Teng‐Fong Wong
A fundamental question in rock physics is how the coupling of confining stress and pore pressure influences geophysical properties, which is manifested by the effective stress behavior of the porous rock. We investigated the effective stress behavior of four water‐saturated limestones with porosities ranging from 13% to 30%. Unlike previous experimental studies limited to the permeability, we also characterized the effective stress coefficients for pore volume change and bulk strain. The pore spaces of three of the limestones (two allochemical oolitic and one micritic) have significant fractions of macropores and micropores. In these three limestones with dual porosity the effective stress coefficients for permeability and pore volume change were observed to be consistently greater than 1, even though that for axial strain was less than 1. In a microscopically homogeneous assemblage, the effective stress coefficients for permeability, bulk volumetric strain, and pore volume change are predicted to be equal to or less than unity. Our data therefore show that these limestones cannot be modeled as microscopically homogeneous. Berryman (1992a, https://doi.org/10.1029/92JB01593) and Berryman (1992b, https://doi.org/10.1103/PhysRevA.46.3307) analyzed theoretically a rock made up of two porous constituents, and our experimental data are in agreement with inequalities he derived for effective stress coefficients of such an assemblage. For comparison, we studied the Leitha limestone that is made up predominately of macropores. Our data showed that all three effective stress coefficients in this case were less than unity, as predicted for a microscopically homogeneous assemblage.

1 September 2016 in Journal of Natural Gas Science and Engineering
Verified
Journal Article
Closed access
FMFanbao Meng
Fanbao Meng
HGHongkui Ge
Hongkui Ge
Wei YanWei Yan
Wei Yan
XWXiaoqiong Wang
Xiaoqiong Wang
SWShan Wu
Shan Wu
JWJianbo Wang
Jianbo Wang