Objective: The objective of this study is to evaluate the effect of a cleaning agent and priming on the bond strength (BS) of a resin cement (RC) to zirconia ceramics after 24 h and 1 year of water-storage. Materials and Methods: Fifty-six Katana and 56 ZirCAD zirconia ceramic plates were prepared and each zirconia brand was divided into four groups (n = 14): (1) untreated; (2) treated with Ivoclean cleaning agent; (3) treated with Monobond Plus coupling agent; (4) treated with Ivoclean + Monobond Plus. Cleaning and coupling agents were applied to zirconia following the manufacturers' instructions. The RC was manipulated, inserted into tubes (0.75 mm diameter/1 mm height) that were positioned on the zirconia surfaces and light activated. Specimens were tested after 24 h and 1 year of water storage. A shear load was applied to the base of the RC cylinders (until failure. Data were analyzed by three-way ANOVA and Tukey tests (α = 5%). Results: No significant difference in BS was noted between zirconia ceramics, except when the combination of cleaning and coupling agents was used. This combination increased the BS for Katana zirconia. One year of water storage leads to a decrease in BS for all experimental groups. Conclusion: The combination of cleaning agent and priming can yield higher BS for Katana at 24 h. BS to zirconia ceramics reduced approximately 50% after 1 year.
1 March 2023 in The Journal of Prosthetic Dentistry
To evaluate the precision of complete-arch digital implant scans using intraoral scanning (IOS) and photogrammetry (PG). Nineteen completely edentulous arches were included. Each arches contained at least four implants. Abutment-level digital scans were taken using IOS (3Shape Trios 3) and PG (Imetric ICam 4D, 1st gen). Each arch was scanned five times with each device. Implant cartesian coordinates were extracted, and the Spatial Fit, Cross-Arch Distance, and Virtual Sheffield tests were conducted. A generalized estimating equation (GEE) analysis was conducted to compare the precision of IOS and PG for the three tests. A GEE was used to assess further the association between jaw type (maxilla vs. mandible) and the precision for each device in all three tests. The significance level was set at α=0.05. PG demonstrated greater precision in all three tests (p < 0.0001). Precision was not significantly associated with jaw type in the PG group (p > 0.05). For IOS, the mandibular arch demonstrated inferior levels of precision compared to the maxilla for the Spatial Fit (p = 0.040), Cross-Arch Distance (p = 0.026), and Virtual Sheffield (p = 0.019) tests. PG represented a more precise scanner for complete-arch digital implant scans. Maxillary arch scans were associated with superior precision compared to scans of the mandible, yet statistical significance was only found in the IOS group. IOS scanning for fixed implant rehabilitation of the edentulous jaw with conventional scan bodies should be approached with caution due to the poor precision, particularly in the mandible. PG represented a more precise scanner for complete-arch digital implant scans.