1 February 2012 in Journal of Dental Research
According to the ‘Adhesion–Decalcification’ concept, specific functional monomers within dental adhesives can ionically interact with hydroxyapatite (HAp). Such ionic bonding has been demonstrated for 10-methacryloyloxydecyl dihydrogen phosphate (MDP) to manifest in the form of self-assembled ‘nano-layering’. However, it remained to be explored if such nano-layering also occurs on tooth tissue when commercial MDP-containing adhesives (Clearfil SE Bond, Kuraray; Scotchbond Universal, 3M ESPE) were applied following common clinical application protocols. We therefore characterized adhesive-dentin interfaces chemically, using x-ray diffraction (XRD) and energy-dispersive x-ray spectroscopy (EDS), and ultrastructurally, using (scanning) transmission electron microscopy (TEM/STEM). Both adhesives revealed nano-layering at the adhesive interface, not only within the hybrid layer but also, particularly for Clearfil SE Bond (Kuraray), extending into the adhesive layer. Since such self-assembled nano-layering of two 10-MDP molecules, joined by stable MDP-Ca salt formation, must make the adhesive interface more resistant to biodegradation, it may well explain the documented favorable clinical longevity of bonds produced by 10-MDP-based adhesives.
1 October 2006 in Journal of Dental Research
Among functional monomers used in contemporary dental adhesives, 10-methacryloyloxydecyl dihydrogen phosphate (MDP) has been found to interact chemically with hydroxyapatite (HAp) most intensively and stably. This effect was thought to be the basis of the superior bonding effectiveness of MDP-based self-etch adhesives to enamel/dentin. To elucidate fully the chemical interaction and reactivity of MDP with HAp, we used 31P CP-MAS NMR spectroscopy and powder x-ray diffraction. In an aqueous ethanol solution, Ca ions were leached from HAp to form, at short term, a MDP-calcium salt (CaMHP2) layered structure on the HAp surface. When MDP was allowed to interact for longer time (< 24 hrs), CaHPO4·2H2O precipitated on top of this MDP-calcium salt layered structure. In conclusion, the intense chemical interaction of MDP with HAp must be ascribed to superficial dissolution of HAp induced by the MDP adsorption and subsequent deposition of MDP-calcium salt with a solubility lower than that of CaHPO4·2H2O.
30 March 2017 in Scientific Reports
Currently, the functional monomer 10-methacryloyloxy-decyl-dihydrogen-phosphate (10-MDP) was documented to chemically bond to zirconia ceramics. However, little research has been conducted to unravel the underlying mechanisms. This study aimed to assess the chemical interaction and to demonstrate the mechanisms of coordination between 10-MDP and zirconium oxide using 1H and 31P magic angle spinning (MAS) nuclear magnetic resonance (NMR) and two dimensional (2D) 1H → 31P heteronuclear correlation (HETCOR) NMR. In addition, shear bond-strength (SBS) tests were conducted to determine the effect of 10-MDP concentration on the bonding effectiveness to zirconia. These SBS tests revealed a 10-MDP concentration-dependent SBS with a minimum of 1-ppb 10-MDP needed. 31P-NMR revealed that one P-OH non-deprotonated of the PO3H2 group from 10-MDP chemically bonded strongly to zirconia. 1H-31P HETCOR NMR indicated that the 10-MDP monomer can be adsorbed onto the zirconia particles by hydrogen bonding between the P=O and Zr-OH groups or via ionic interactions between partially positive Zr and deprotonated 10-MDP (P-O−). The combination of 1H NMR and 2D 1H-31P HETCOR NMR enabled to describe the different chemical states of the 10-MDP bonds with zirconia; they not only revealed ionic but also hydrogen bonding between 10-MDP and zirconia.
1 March 2002 in Biomaterials
1 September 2010 in Acta Biomaterialia
1 December 2002 in Biomaterials