Liguo Zhong

Liguo Zhong

Auto-generated profile, based on publicly available information

Liguo Zhong

Institute of Unconventional Oil and Gas Science and Technology, China University of Petroleum (Beijing), Beijing, China

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 June 2016
Verified
Conference Paper
Closed access
DJDongqi Ji
Dongqi Ji
SYSheng Yang
Sheng Yang
HZHe Zhong
He Zhong
MDMingzhe Dong
Mingzhe Dong
ZCZhangxing John Chen
Zhangxing John Chen
LZLiguo Zhong
Liguo Zhong
Steam-Assisted Gravity drainage (SAGD) is a popular approach for oil sands recovery, in which a steam chamber is developed inside reservoir with heated up bitumen flowing downwards along the edge of the steam chamber to production well by gravity. To improve the production performance of SAGD, solvent co-injection with steam (called ES-SAGD) is also proposed. In both SAGD and ES-SAGD, the penetration of low viscosity gas phase into viscous bitumen induces fingering at the steam chamber edge, resulting in non-uniform steam chamber. In this study, for the first time, the phenomenon of fingering is re-examined under the condition of mobile initial-water in oil sands through a newly designed reservoir simulation model. The effect of Solution Gas to Oil Ratio (GOR) on fingering in SAGD is also studied. In addition, the impact of solvent-water-bitumen phase behavior, which is critical to the amount of gas phase, on fingering is examined in ES-SAGD. The results reveal that fingering takes place at the oil zone on the top of steam chamber in SAGD, due to the ex-solution of solution gas under elevated temperature. The addition of solvent in ES-SAGD enhances the fingers by reducing the partial pressure of the solution gas and increasing the amount of solution gas at the top of steam chamber. It is found that the flow of the initial-water in oil sands mitigates the degree of fingering and helps stabilize steam chamber edge. This re-examination of fingering in SAGD and ES-SAGD demonstrates that the mobility of the initial water in oil sands has to be taken in account in the analysis of steam chamber instability.

7 July 2020 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Verified
Journal Article
Closed access
XHXiaodong Han
Xiaodong Han
LZLiguo Zhong
Liguo Zhong
YLYigang Liu
Yigang Liu
QWQiuxia Wang
Qiuxia Wang
CWCheng Wang
Cheng Wang
Thermal stimulation with horizontal wells has been conducted for more than 10 years in Bohai Oilfield. With the increase of the stimulation cycle, the aggravation of steam channeling and non-uniform utilization of horizontal section under high-temperature conditions seriously influence the production performance. For further improving the oil recovery of offshore heavy-oil reservoirs developed with horizontal well thermal stimulation, a new polyacrylamide polymer gel with strong gel strength, controllable gelling time, and good stability for offshore platform was developed. The gel system has good compatibility with produced sewage and is feasible to use production sewage for gel solution preparation instead of distilled water. The plugging rates in both high permeability and low permeability sand packs are over 98% at conditions of 200°C. The corresponding recovery rate of the sand packs is greatly improved by about 16.7% and 32.4%, respectively. The gel agent has good plug removing performance and more than 90% of the gel can be removed in less than 20 hours with the added plug removing agent. The gel has little effect on demulsification and dehydration of the produced water, which could meet the offshore technical requirement. Besides, a formula selection chart is proposed and established for easy and fast determination of the optimized polyacrylamide and resorcinol concentration, which could provide technical support for steam plugging and profile adjustment in offshore high-temperature reservoir.