Alexander Pyymaki Perros

Alexander Pyymaki Perros

Auto-generated profile, based on publicly available information

Alexander Pyymaki Perros

Nanovate Oy, Micronova, Espoo, Finland

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 January 2017 in IEEE Journal of Photovoltaics
Verified
Journal Article
Closed access
XCXuemei Cheng
Xuemei Cheng
PRPaivikki Repo
Paivikki Repo
HHHaug Halvard
Haug Halvard
APAlexander Pyymaki Perros
Alexander Pyymaki Perros
EMErik Stensrud Marstein
Erik Stensrud Marstein
HSHele Savin
Hele Savin
Atomic layer deposited hafnium oxide is shown to provide good surface passivation of low resistivity, n-type crystalline Si wafers after a low temperature anneal. The surface passivation is related to a fixed negative charge, as well as an excellent interface with the crystalline Si wafer. In this paper, the influence of four deposition parameters on the HfO 2 passivation properties, namely precleaning, precursors, deposition temperature, and postannealing temperature, is discussed. Minority carrier lifetimes of 1.9 ms (surface recombination velocity (SRV) 7.7 cm/s) on float zone n-type wafers and 1.7 ms (SRV 11 cm/s) on Czochralski n-type wafers, under optimized deposition conditions and a postannealing process, have been measured. A significant improvement of the surface passivation is observed after 100 h light soaking, resulting in a carrier lifetime of 2.5 ms. Fitting of the results by a two-defect charge trapping/detrapping model indicates that additional light-induced negative charges enhance the field effect passivation, which is also consistent with the experimental results. Due to its high refractive index and the obtained good surface passivation of Si wafers, HfO 2 has a great potential as a surface passivation material, e.g., in the fabrication of high-efficiency Si solar cells.

18 October 2016 in ACS Photonics
Verified
Journal Article
Closed access
JRJohn Rönn
John Rönn
LKLasse Karvonen
Lasse Karvonen
CKChristoffer Kauppinen
Christoffer Kauppinen
APAlexander Pyymaki Perros
Alexander Pyymaki Perros
NPNasser Peyghambarian
Nasser Peyghambarian
ZSZhipei Sun
Zhipei Sun

8 February 2014 in Advanced Materials Interfaces
Verified
Journal Article
Closed access
PDF file
JLJuan Li
Juan Li
XTXuelin Tian
Xuelin Tian
APAlexander Pyymaki Perros
Alexander Pyymaki Perros
SFSami Franssila
Sami Franssila
VJVille Jokinen
Ville Jokinen

29 December 2011 in The Journal of Physical Chemistry C
Verified
Journal Article
Closed access
HSHanna Saarenpää
Hanna Saarenpää
ESEssi Sariola-Leikas
Essi Sariola-Leikas
APAlexander Pyymaki Perros
Alexander Pyymaki Perros
JKJuha M. Kontio
Juha M. Kontio
AEAlexander Efimov
Alexander Efimov
NTNikolai V. Tkachenko
Nikolai V. Tkachenko

27 November 2013 in Journal of Physics D: Applied Physics
Verified
Journal Article
Closed access
APAlexander Pyymaki Perros
Alexander Pyymaki Perros
HHHanna Hakola
Hanna Hakola
Timo SajavaaraTimo Sajavaara
Timo Sajavaara
THTeppo Huhtio
Teppo Huhtio
Harri LipsanenHarri Lipsanen
Harri Lipsanen
Impurities in aluminum nitride films prepared by plasma enhanced atomic layer deposition using NH3-, N2/H2- and N2-based plasmas are investigated by combining time-of-flight elastic recoil detection analysis (ERDA) and Fourier transform infrared spectroscopy. Different atomistic growth mechanisms are found to exist between the plasma chemistries. N2-plasma is shown as not suitable for the low-temperature deposition of AlN. Films deposited by NH3- and N2/H2-based processes are nitrogen rich and heavily hydrogenated. Carbon impurities exist at higher concentrations for the N2/H2-processes. The discovery of nitrile groups in the films indicates that carbon impurities can be partially attributed to an undesirable reaction occurring during the plasma step between nitrogen species and CH groups. Unremoved ligands from the metal precursor are the other source of carbon. A comparison of the hydrogen content within the films as determined by infrared absorption spectroscopy and ERDA suggests the NH3-based films have large quantities of unbonded hydrogen, whereas hydrogen in the N2/H2-based films is mostly in the form NHx. For the N2/H2-based processes, the addition of argon into the plasma mixture is shown to enhance amine formation.

1 January 2016 in AIP Advances
Verified
Journal Article
Open access
PDF file
VDVeer Dhaka
Veer Dhaka
APAlexander Perros
Alexander Perros
SNShagufta Naureen
Shagufta Naureen
NSNaeem Shahid
Naeem Shahid
HJHua Jiang
Hua Jiang
Harri LipsanenHarri Lipsanen
Harri Lipsanen
Low temperature (∼200 °C) grown atomic layer deposition (ALD) films of AlN, TiN, Al2O3, GaN, and TiO2 were tested for protective capping and surface passivation of bottom-up grown III-V (GaAs and InP) nanowires (NWs), and top-down fabricated InP nanopillars. For as-grown GaAs NWs, only the AlN material passivated the GaAs surface as measured by photoluminescence (PL) at low temperatures (15K), and the best passivation was achieved with a few monolayer thick (2Å) film. For InP NWs, the best passivation (∼2x enhancement in room-temperature PL) was achieved with a capping of 2nm thick Al2O3. All other ALD capping layers resulted in a de-passivation effect and possible damage to the InP surface. Top-down fabricated InP nanopillars show similar passivation effects as InP NWs. In particular, capping with a 2 nm thick Al2O3 layer increased the carrier decay time from 251 ps (as-etched nanopillars) to about 525 ps. Tests after six months ageing reveal that the capped nanostructures retain their optical properties. Overall, capping of GaAs and InP NWs with high-k dielectrics AlN and Al2O3 provides moderate surface passivation as well as long term protection from oxidation and environmental attack.