Writing Conductive Lines with Hot Tips: The interface within devices between conductors, semiconductors, and insulators is usually created by stacking patterned layers of different materials. For flexible electronics, it can be advantageous to avoid this architectural constraint. Graphene oxide, formed by chemical exfoliation of graphite, can be reduced to a more conductive form using chemical reductants.
Wei
et al. (p. 1373 ) now show that layers of graphene oxide can also be reduced using a hot atomic force microscope tip to create materials comparable to those of organic conductors. This process can create patterned regions (down to 12 nanometers in width) that differ in conductivity by up to four orders of magnitude.
Diluted magnetic semiconductor Zn1−xMnxO nanowires were synthesized via an in situ doping of manganese in ZnO nanowires using vapor phase growth at 500 °C. The maximum content of the manganese in the ZnO is around 13 at. %, approaching the maximum thermal equilibrium limit of Mn solubility in ZnO at the growth temperature. Structure and composition analysis revealed that the manganese was doped into the lattice structure, forming solid solution instead of precipitation. Magnetic property measurements revealed that the as-doped Zn1−xMnxO nanowires exhibit ferromagnetic behavior with Curie temperature around 37 K.
Here we report on a scalable and direct growth of graphene micro ribbons on SiO2 dielectric substrates using a low temperature chemical vapor deposition. Due to the fast annealing at low temperature and dewetting of Ni, continuous few-layer graphene micro ribbons grow directly on bare dielectric substrates through Ni assisted catalytic decomposition of hydrocarbon precursors. These high quality graphene micro ribbons exhibit low sheet resistance of ~700 Ω −2100 Ω, high on/off current ratio of ~3, and high carrier mobility of ~655 cm2V−1s−1 at room temperature, all of which have shown significant improvement over other lithography patterned CVD graphene micro ribbons. This direct approach can in principle form graphene ribbons of any arbitrary sizes and geometries. It allows for a feasible methodology towards better integration with semiconductor materials for interconnect electronics and scalable production for graphene based electronic and optoelectronic applications where the electrical gating is the key enabling factor.