Investigations of impurity centers, electrical resistivity and microstructure of BaTiO3 ceramics doped with rare-earth ions Y, La, Nd, Sm, Dy and Lu at concentrations x = 0.001–0.005 were carried out. Electron paramagnetic resonance, X-ray diffraction and electron microscopy were used for measurements. The most intense EPR lines were shown to belong to paramagnetic complexes Fe3+–VO and Ti3+–Ln3+ (Ln = rare-earth ion, VO = oxygen vacancy). A change in symmetry of the center Fe3+–VO at the transition temperature from the ferroelectric to paraelectric phase has been revealed for the first time. Measurements of the dependence of EPR line intensities and electrical resistivity with rare-earth ion concentrations were performed. The observed correlation in their behaviour showed an essential role of the identified paramagnetic complexes in the appearance of BaTiO3 ceramic semiconducting properties and the positive temperature coefficient of resistance (PTCR) effect. The latter effect was at a maximum for x ≈ xc where xc ≈ 0.002–0.003 is the critical rare-earth ion concentration which determines the excess charge compensation mechanism. Up to xc, the rare earths investigated, (except for the small ion Lu), substitute for barium, and the main compensation mechanism is an electronic mechanism. At high concentrations (x > xc) in the case of large ions (e.g. La), substitution is at barium sites, with the creation of titanium vacancies, whereas intermediate ions (e.g. Y) begin to substitute for titanium. The influence of impurities on the BaTiO3 microstructure, including the grain sizes, is discussed.
Structural, electric, and magnetic properties of the bulk polycrystalline samples with nominal composition have been investigated in the work. As follows from the results of chemical and x-ray structural analyses, the increase in brings about the rise in the number of structural vacancies in both lanthanum and oxygen sublattices. The influence of the variation of the vacancy number on peculiar features of the transition from ferromagnetic metallic state to paramagnetic state with activated conductivity has been studied in detail. The conclusion is made that the rise in the number of structural vacancies gives rise not only to the enhancement of magnetic inhomogeneity and broadening of the magnetic transition, but also to the increase in the temperature of magnetic transition. It is demonstrated that the changes in magnetic parameters also result in the increase of the temperatures of resistivity and magnetoresistance peaks as well as in the change of the character of the temperature dependence of electric resistance.
1 January 2007 in Journal of the European Ceramic Society
(1−x)BaTiO3–xM0.5Bi0.5TiO3 (M = Li, Na, K) solid solutions were prepared using BaTiO3 pre-synthesized by oxalate method. The stability limits of (1−x)BaTiO3–xLi0.5Bi0.5TiO3 solid solutions have been established. It was shown that increase in M0.5Bi0.5TiO3 concentration results in reduction of ceramic grain size in the (1−x)BaTiO3−xM0.5Bi0.5TiO3 (M = Li, Na, K) system. It was found that the positive temperature coefficient of resistance (PTCR) effect in lead-free materials is due to the presence of a semiconductor core, which is formed by sintering under reducing atmosphere, and dielectric grain boundaries, formed on additional oxidation in air. The use of barium titanate, pre-synthesized by oxalate method, in the synthesis of solid solutions reduced the sintering temperature of ceramics compared with solid state reaction technique. By comparing the electrical properties of the synthesized lead-containing and lead-free materials, it has been shown that lead-free materials exhibit better electrical properties for practical use compared with lead-containing materials.