1 August 2025 in IEEE Sensors Journal
A Mach-Zehnder interferometer (MZI) based on a polarization-maintaining fiber-few-mode fiber (PMF-FMF) structure is proposed to achieve high-sensitivity vector torsion sensing. The effects of fiber lengths, core offset directions, and offset magnitudes of both PMF and FMF on the interference spectra are investigated. Leveraging the properties of PMF, when the sensor is twisted, changes in the polarization state of the transmitted light alter the intensity of interference dips, causing the wavelengths of the envelope valleys to shift in opposite directions, which enables the discrimination of torsion direction. Additionally, the influence of PMF and FMF lengths on the interference spectra is studied, and experimental measurements of torsion, temperature, and strain sensing are conducted. Experimental results show that the maximum torsion sensitivity for clockwise (CW) rotation is 0.91 nm/(rad/m), and that for counterclockwise (CCW) rotation is -0.61 nm/(rad/m). Additionally, the sensor features simple fabrication, low sensitivity to strain and temperature interference, and a measurement error of less than 4%. These characteristics make it highly suitable for structural health monitoring applications in civil engineering and aerospace industries.
11 February 2025 in Journal of Lightwave Technology
Photosensitive polymers serve as critical adhesives in optical devices, with their thermal strain coefficient determining the performance of temperature-dependent loss in such devices. To accurately measure the true thermal strain coefficient of the adhesive, we proposed a measurement scheme of internal strain distribution in photosensitive polymers by using an optical frequency domain reflectometry (OFDR) system. In our scheme, a self-referencing approach is used to eliminate the temperature-to-strain crosstalk caused by temperature variations in the tested sample, thereby obtaining the true thermal strain coefficient of the tested sample. In our experiment, a 10 cm single-mode fiber (SMF) is embedded within the 2 mm × 2 mm × 100 mm photosensitive polymer, and we use the high spatial resolution of the OFDR system to realize the distributed strain measurements of the SMF. A thermal strain coefficient of 19.108 μϵ/°C is obtained when the temperature ranges from 30 °C to 120 °C. The temperature-to-strain crosstalk is 9.131 μϵ/°C, and the spatial resolution of the OFDR is 1.28 mm. In addition, we validated the stability of the entire experimental setup by conducting long-term measurements under fixed environmental conditions, during which the system fluctuations remained within approximately ± 3 GHz. The experimental results can provide valuable insights for the selection of adhesives and the determination of optimal curing time of the passive optical devices fabrication in the field of optical fiber communication.
1 September 2026 in Journal of Optics
A high-sensitivity fiber-optic tilt sensor based on Mach–Zehnder interference is proposed. The design uses a controlled core-offset to excite higher-order cladding modes in a few-mode fiber (FMF) and incorporates a spherical structure to enhance intermodal coupling efficiency. This configuration yields high fringe contrast and provides a sensitive, monotonic response to tilt angle variation. The influences of FMF length on the free spectral range, core-offset higher-order modes excitation, and spherical structure diameter on interference fringe contrast were systematically investigated. Experimental results demonstrated that, over a tilt range from 15.26° to 32.47°, the sensor achieves a sensitivity as high as −5.07 nm/°, while the temperature sensitivity is only 0.03 nm°C −1 between 24 °C and 36 °C. The corresponding temperature cross-sensitivity is as low as 0.006°/°C. The combination of high tilt responsivity and suppressed thermal crosstalk makes the sensor well suited for stable operation in complex environments and suggests strong potential for deformation monitoring of engineering structures.