21 February 2012 in Transportation Planning and Technology
This study investigates the impacts of traffic signal timing optimization on vehicular fuel consumption and emissions at an urban corridor. The traffic signal optimization approach proposed integrates a TRANSIMS microscopic traffic simulator, the VT-Micro model (a microscopic emission and fuel consumption estimation model), and a genetic algorithm (GA)-based optimizer. An urban corridor consisting of four signalized intersections in Charlottesville, VA, USA, is used for a case study. The result of the case study is then compared with the best traffic signal timing plan generated by Synchro using the TRANSIMS microscopic traffic simulator. The proposed approach achieves much better performance than that of the best Synchro solution in terms of air quality, energy and mobility measures: 20% less network-wide fuel consumption, 8–20% less vehicle emissions, and nearly 27% less vehicle-hours-traveled (VHT).
10 December 2013 in Physical Review E
In order to investigate collective effects of interactions between pedestrians and attractions, this study extends the social force model. Such interactions lead pedestrians to form stable clusters around attractions, or even to rush into attractions if the interaction becomes stronger. It is also found that for high pedestrian density and intermediate interaction strength, some pedestrians rush into attractions while others move to neighboring attractions. These collective patterns of pedestrian movements or phases and transitions between them are systematically presented in a phase diagram. The results suggest that safe and efficient use of pedestrian areas can be achieved by moderating the pedestrian density and the strength of attractive interaction, for example, in order to avoid situations involving extreme desire for limited resources.
24 August 2017 in Physical Review E
We numerically study jamming transitions in pedestrian flow interacting with an attraction, mostly based on the social force model for pedestrians who can join the attraction. We formulate the joining probability as a function of social influence from others, reflecting that individual choice behavior is likely influenced by others. By controlling pedestrian influx and the social influence parameter, we identify various pedestrian flow patterns. For the bidirectional flow scenario, we observe a transition from the free flow phase to the freezing phase, in which oppositely walking pedestrians reach a complete stop and block each other. On the other hand, a different transition behavior appears in the unidirectional flow scenario, i.e., from the free flow phase to the localized jam phase and then to the extended jam phase. It is also observed that the extended jam phase can end up in freezing phenomena with a certain probability when pedestrian flux is high with strong social influence. This study highlights that attractive interactions between pedestrians and an attraction can trigger jamming transitions by increasing the number of conflicts among pedestrians near the attraction. In order to avoid excessive pedestrian jams, we suggest suppressing the number of conflicts under a certain level by moderating pedestrian influx especially when the social influence is strong.
1 January 2022 in Resuscitation
1 July 2011 in KSCE Journal of Civil Engineering
TRANSIMS, a travel demand modeling software package initially developed by the Los Alamos National Laboratory (LANL), enables modeling of individual activities and provides second-by-second simulation results on vehicular movements. TRANSIMS has been applied more than a decade, but calibration and validation of TRANSIMS Microsimulator have not received proper attention from transportation engineering community. This paper presents a case study of a TRANSIMS Microsimulator calibration and validation using an experimental design approach. An urban arterial network consisted of four signalized intersections was calibrated against field measured travel times and traffic count data. The distributions of travel times and traffic count obtained from the multiple replications of the default parameter values were not able to replicate field conditions, while the proposed approach did well. Even though this case study used a small corridor network in urban area, the calibration and validation procedure could be extended to a larger scale network in TRANSIMS modeling as well as transportation planning applications.