1 July 2009 in Desalination
1 February 2013 in Water Science & Technology
The removal performance of heavy metals by two experimental full-scale membrane bioreactors (microfiltration and ultrafiltration) and the influence of activated sludge total suspended solid (TSS) concentration were studied under real operational conditions. Influent and effluent Be, Sc, V, Cr, Mn, Co, Ni, Cu, Zn, As, Mo, Cd, Ba, Sn, Sb, Pb and U concentrations were analysed by inductively coupled plasma-mass spectrometry. An average contamination rate for most of the analysed heavy metals was observed in raw wastewater, resulting in effluents without limitation for reuse in agricultural destinations according to Spanish law. Removal efficiencies up to 80% were obtained regardless of whether microfiltration or ultrafiltration membranes were used, except for As, Mo and Sb. The removal yields of different heavy metals can be strengthened by increasing the activated sludge TSS concentration, mainly at concentrations above 10 g/L.
30 August 2012 in Journal of Environmental Science and Health, Part A
The fate and removal of phenanthrene (Phen), fluoranthene (F) and pyrene (Py) in urban wastewater treatment by membrane bioreactor (MBR) with low influent polycyclic aromatic hydrocarbons (PAHs) concentration were studied. A full experimental ultrafiltration MBR with a pre-denitrification configuration and capacity to treat 20 m3/d was employed. The system was operated with real urban wastewater, to which a concentration of PAHs was added. A constant purge was achieved in order to obtain 12 d of sludge retention time and the hydraulic retention time was 34 h. Concentration of PAHs was determined by Gas Chromatography and Mass Spectrometry with Twister, and mass balance on the MBR system were calculated. Data were supplemented by respirometric analyses, isolation of PAHs degrading microorganisms and bench-scale experiments. All effluent samples presented concentrations of PAHs, with removal levels of 91% and 92% for F and Py respectively, while for Phen performance did not surpass 82%. In spite of the high hydrophobicity of the tested compounds, their accumulation in the biomass was scarce and the sludge presented a low PAH concentration. The experiments reveal that PAHs removal is mainly due to air stripping, with biodegradation and adsorption making an insignificant contribution.
19 August 2014 in Journal of Environmental Science and Health, Part A
Five different wastewater COD fractionation methods were employed for simulating an experimental MBR wastewater treatment plant using WEST. The predictions of dynamic simulations using as input the data obtained according to each influent characterization methodology were compared with the results of the experimental system and differences between experimental and predicted values were analyzed in order to select the fractionation method which provides the best fitting and minimizes errors. Three of these methods were based on the determination of the biodegradable fractions using respirometric assays of real wastewater filtered through 0.45- and 0.22-μm pore size filters or adding a previous flocculation step before filtration. Moreover, a method based on physicochemical analyses and another one based on theoretical coefficients were also compared. Simulated system performance and effluent quality greatly depended upon the influent characterization and the proper model calibration. Thus the importance of selecting a suitable fractionation methodology is high, especially in MBR systems working at specific operational conditions that may alter COD fractions. In this study, MLSS in the bioreactors and sludge supernatant COD concentrations were better predicted when the influent characterization was based on respirometric methods. Both the method based on theoretical coefficients and the physicochemical method underestimated the particulate inert fraction and therefore, also the MLSS concentrations. Moreover, these results showed that for a correct effluent COD prediction in MBR systems, it is necessary to take into account that the membrane retained part of the soluble inert fraction.
16 March 2012 in Journal of Environmental Science and Health, Part A
Evolution of filamentous bacteria in two full-scale experimental MBR systems (microfiltration and ultrafiltration) was studied during two years. Sludge Retention Time (SRT) and Hydraulic Retention Time (HRT) were modified and acted as variables, together with temperature and variation in loading. With SRT values between 20 and 35 d and HRT between 31 and 40 h, both MBR systems presented a high density of filamentous bacteria, according to the Filamentous Index (FI) and Simplified Technique of Filamentous Count (STFC). Highest density was achieved when contaminant loads were high and temperature was low. However, the elevated presence of filamentous bacteria did not affect the quality of effluent or the permeability of the membranes. Nocardioform bacteria showed a high degree of adaptation to the characteristics of the system. Predominance of Nocardioforms gave rise to isolated episodes of massive growth at temperatures between 15 and 20°C, which in turn caused episodes of intense foaming whose most significant consequence was a loss in biomass, leading to a slight increase in transmembrane pressure. In the light of these results, FI and STFC should not be considered as suitable tools for predicting operational problems deriving from filamentous bacteria in MBR systems, which could be prevented through identification.
1 May 2005 in Journal of Environmental Science and Health, Part A
Two different peat types (fibrist and saprist) were compared to examine their respective wastewater treatment capacity in peat beds under different hydraulic loadings (1.8, 1.2, 0.9, and 0.6 m3/m2 ...