Science, resource management, and defense need algorithms capable of using airborne or satellite imagery to accurately map bathymetry, water quality, and substrate composition in optically shallow waters. Although a variety of inversion algorithms are available, there has been limited assessment of performance and no work has been published comparing their accuracy and efficiency. This paper compares the absolute and relative accuracies and computational efficiencies of one empirical and five radiative‐transfer‐based published approaches applied to coastal sites at Lee Stocking Island in the Bahamas and Moreton Bay in eastern Australia. These sites have published airborne hyperspectral data and field data. The assessment showed that (1) radiative‐transfer—based methods were more accurate than the empirical approach for bathymetric retrieval, and the accuracies and processing times were inversely related to the complexity of the models used; (2) all inversion methods provided moderately accurate retrievals of bathymetry, water column inherent optical properties, and benthic reflectance in waters less than 13 m deep with homogeneous to heterogeneous benthic/ substrate covers; (3) slightly higher accuracy retrievals were obtained from locally parameterized methods; and (4) no method compared here can be considered optimal for all situations. The results provide a guide to the conditions where each approach may be used (available image and field data and processing capability). A re‐analysis of these same or additional sites with satellite hyperspectral data with lower spatial and radiometric resolution, but higher temporal resolution would be instructive to establish guidelines for repeatable regional to global scale shallow water mapping approaches.
Bathymetry and the spatial distribution of benthic cover in coastal waters are of key importance in managing and monitoring our coastal water environments. Currently very little of the Western Australian shallow coastal water habitats are mapped, and for those maps that do exist, the spatial resolution generally is poor and the information is dated. Aircraft and space-borne hyperspectral sensors have been shown to be useful in imaging substrate features in shallow coastal waters. This paper describes a method for quantitatively estimating both bathymetry and benthic cover in shallow waters from hyperspectral imagery. The method incorporates a shallow water reflectance model, which accounts for the water column absorption and backscattering, water depth and substrate reflectance. The model was tested against simulated reflectance data, demonstrating the models' ability to retrieve appropriate fractional coverage of sediment, sea grass and brown algae for depths ranging from 1 - 12 m. The model was applied to a HyMap image encompassing a portion of the Jurien Bay Marine Park off the coast of Western Australia. The retrieved benthic cover products were compared to underwater video observations sampled within the image. The comparison shows the method's great potential for characterizing key aspects of marine ecosystems from remotely sensed hyperspectral data.
30 July 2008 in Journal of Geophysical Research: Oceans
Knowledge of the concentration of total suspended sediment (TSS) in coastal waters is of significance to marine environmental monitoring agencies to determine the turbidity of water that serve as a proxy to estimate the availability of light at depth for benthic habitats. TSS models applicable to data collected by satellite sensors can be used to determine TSS with reasonable accuracy and of adequate spatial and temporal resolution to be of use for coastal water quality monitoring. Thus, a study is presented here where we develop a semi-analytic sediment model (SASM) applicable to any sensor with red and near infrared (NIR) bands. The calibration and validation of the SASM using bootstrap and cross-validation methods showed that the SASM applied to Moderate Resolution Imaging Spectroradiometer (MODIS)-Aqua band 1 data retrieved TSS with a root mean square error (RMSE) and mean averaged relative error (MARE) of 5.75 mg/L and 33.33% respectively. The application of the SASM over our study region using MODIS-Aqua band 1 data showed that the SASM can be used to monitor the on-going, post and pre-dredging activities and identify daily TSS anomalies that are caused by natural and anthropogenic processes in coastal waters of northern Western Australia.