This paper discusses the sorbent properties of magnetic activated carbons and biochars produced by wet impregnation with iron oxides. The sorbents had magnetic susceptibilities consistent with theoretical predictions for carbon-magnetite composites. The high BET surface areas of the activated carbons were preserved in the synthesis, and enhanced for one low surface area biochar by dissolving carbonates. Magnetization decreased the point of zero charge. Organic compound sorption correlated strongly with BET surface areas for the pristine and magnetized materials, while metal cation sorption did not show such a correlation. Strong sorption of the hydrophobic organic contaminant phenanthrene to the activated carbon or biochar surfaces was maintained following magnetite impregnation, while phenol sorption was diminished, probably due to enhanced carbon oxidation. Copper, zinc and lead sorption to the activated carbons and biochars was unchanged or slightly enhanced by the magnetization, and iron oxides also contributed to the composite metal sorption capacity. While a magnetic biochar with 219 ± 3.7 m(2)/g surface area nearly reached the very strong organic pollutant binding capacity of the two magnetic activated carbons, a magnetic biochar with 68 ± 2.8 m(2)/g surface area was the best metal sorbent. Magnetic biochars thus hold promise as more sustainable alternatives to coal-derived magnetic activated carbons.
Absolute bacterial quantification receives little serious attention in the literature compared to sequencing, conceivably because it is considered unimportant and facile, or because existing methods are tedious, laborious and/or biased in nature. This is particularly true in engineered systems, including activated sludge, where such information underpins their design and operation. To overcome these limitations we built upon existing work and optimised and comprehensively validated, through comparison with epifluorescence microscopy (EFM), a rapid and precise flow cytometric protocol to enumerate total bacterial numbers in activated sludge. Insights into potential biases were evaluated using appropriate statistical analyses on this comparison, which spanned four orders of magnitude, as well as comparing volatile suspended solid (VSS) concentrations. The results suggest flow cytometry (FCM) is a rapid, reproducible and economical technique for quantifying total bacterial numbers and biomass concentrations in activated sludge, despite within order of magnitude discrepancies with EFM counts, which had inherent and evidently greater errors and biases than FCM. The use of FCM for routine monitoring over both EFM and VSS should help further understanding of the microbial ecology in, and the operation of, engineered systems.
Addition of activated carbon (AC) or biochar (BC) to sediment to reduce the chemical and biological availability of organic contaminants is a promising in-situ remediation technology. But concerns about leaving the adsorbed pollutants in place motivate research into sorbent recovery methods. This study explores the use of magnetic sorbents. A coal-based magnetic activated carbon (MAC) was identified as the strongest of four AC and BC derived magnetic sorbents for polycyclic aromatic hydrocarbons (PAHs) remediation. An 8.1% MAC amendment (w/w, equal to 5% AC content) was found to be as effective as 5% (w/w) pristine AC in reducing aqueous PAHs within three months by 98%. MAC recovery from sediment after three months was 77%, and incomplete MAC recovery had both, positive and negative effects. A slight rebound of aqueous PAH concentrations was observed following the MAC recovery, but aqueous PAH concentrations then dropped again after six months, likely due to the presence of the 23% unrecovered MAC. On the other hand, the 77% recovery of the 8.1% MAC dose was insufficient to reduce ecotoxic effects of fine grained AC or MAC amendment on the egestion rate, growth and reproduction of the AC sensitive species Lumbriculus variegatus.
Background: One of the key indicators of the degradation of the environment is the noise level. This has necessitated this study on the evaluation of the public, perceptional awareness, sources, effects, and mitigation measures on environmental noise pollution. Methods: The population was estimated and 385 structured questionnaires were estimated and administered by random purposive sampling. About 358 questionnaires were retrieved. Data were analyzed using SPSS and Excel statistical software. Results: About 90.2% of the respondents had relevant awareness and its effects on environmental noise while 9.8% of the respondent did not. Traffic, generators, commercial and light industry sources of noise, and their severity were ranked in a descending order using the Likert scale. Hearing impairment, annoyance, stress, distraction during exposure were ranked in a descending order using the Likert scale. Single-factor ANOVA on the sources of noise and their severity, awareness of the various effects of noise, and responses during exposure showed that there were significant differences as P<0.05 using a confidence level of 95%. About 61.7% of respondents complained of environmental noise, 72.6% respondents received complaints about environmental noise, 87.7% of respondents were not aware of any government agency monitoring noise pollution, 72.2% of the respondents had done nothing regarding noise prevention, and 91.1% respondents wanted a proactive decision in mitigating environmental noise pollution. Conclusion: There is an inadequate coping strategy. Strategic planning in mitigating environmental noise in urban and semi-urban areas is a necessity and there is a need for public enlightenment by government monitoring agencies.
1 December 2023 in European Journal of Applied Science, Engineering and Technology
The study was designed to investigate the efficacy of Bio-Coagulants in water treatment settling tanks using alum (the commercially available coagulant) as a control for comparison. The study employed the preparation of synthetic turbid water using clay as a source of turbidity, jar tests and settling columns to construct settling curves for evaluating removal efficiencies of the biocoagulants, using standard procedures. The findings of the study revealed significant linear correlation (R2 = 0.9967) between clay suspension dosage (x) and turbidity (y), which enabled the replication of synthetic turbid water of the desired turbidity using clay. The equation representing the relationship was found to be y = 1.0705x - 9.7131. From the jar tests, the optimum dosages of the coagulants were 3mg/l, and 8mg/l for M. Oleifera seed extract and watermelon seed extract respectively as coagulants. These dosages resulted in 97 and 91.6% turbidity removal for the respective coagulants. Also, the optimum removal efficiencies observed from the settling column tests were 97%, 84.5% and 70.8% using alum, Moringa oleifera and watermelon seeds, respectively. The study concluded that the plant dimensions designed using alum as coagulant were the most economical followed closely by the one designed using M. Oleifera seed extract (3m width by 37.2m length by 2.5m depth; and 3m wide by 37.8m length by 2.5m depth, respectively). The researcher therefore, recommends that M. Oleifera seed extract could be a viable alternative to alum as a coagulant for use in water treatment settling tanks.