The cable accessory is the key to ensure the safety of transmission lines. Existing researches indicate that cable accessories always break down in the process of switching. Except the high-frequency transient overvoltage, the high frequency characteristics of the cable accessory are worthy to be paid more attention. In this paper, based on the measurements of the dielectric spectroscopy of insulating materials of ethylene propylene diene monomer (EPDM), silicone rubber (SIR), the cross-linked polyethylene (XLPE) and their semiconducting materials in ranges from 1 MHz to 1 GHz, we simulated four models of the electric field distribution in cable accessory under 35kV DC voltage and AC voltage, and respectively superimposed transient voltage. The results show that the conductivity of insulating materials of EPDM, SIR and XLPE increases about two to three orders of magnitude with the increase of the frequency, while their permittivity hardly changes. However, the conductivity of semiconducting materials of the three increases and the permittivity decreases. Among the three semiconducting materials, the conductivity and permittivity of the outer semiconducting material of the XLPE cable vary more. The simulations show that the electric field strength at the interface between the cable and the cable accessory is above security threshold under high-frequency transient voltage. The electric field distribution in cable accessory is within the safety threshold when frequency is 1 MHz. However, the electric field strength at the interface between the cable and the cable accessory is 2.765 kV / mm and 5.613 kV / mm respectively when the frequency increases to 100 MHz and 1000 MHz, which may cause interface breakdown and seriously influence the reliability of the cable accessory.
3 January 2020 in Angewandte Chemie International Edition
2D Materials In their Communication on page 1074, J. Zhang and co‐workers describe violet phosphorus single crystals and violet phosphorene. The structure was determined by single‐crystal X‐ray diffraction and observed by HRTEM. Violet phosphorus is more stable than black phosphorus.
Polypropylene (PP) has great electric insulation performance and it is environmentally friendly, which makes it has a great potential to be used as the main insulation for HVDC cables. Adding elastomers is a common way to improve its flexibility, which may bring variation of material structure, thus influencing the electric performance. In this work, the electrical aging properties of polypropylene and its polyolefin elastomer composites were obtained. Polypropylene polyolefin elastomer (POE) composites were made with 20, 30, 40, 50, 60wt% of POE content. The breakdown strength, conductivity and electrical aging lifetime of PP/POE composites with different POE contents were tested. The ageing lifetime of PP/POE composites were tested with step-stress method, and the ageing parameter of inverse power law is calculated. The results show that with the increase of POE content, the breakdown strength of most PP-POE composites decreases. But the 40wt% PP/POE composites have the highest breakdown strength among all the PP-POE composites. The current density and the aging life have similar trends with the BD strength. The conductivity increases with the increase of electric field, and the conductivity of pure PP are lower than that of PP/POE composites. Step-stress tests shows that the total aging time decreases with the increase of POE content. At low field strength, the 40wt% PP-POE composites have a longer aging lifetime than other composites. The 40wt% PP-POE composites show the best electrical properties under DC voltage among all the composites.