This paper presents a novel signal technique for Ku-band automobile frequency-modulated continuous-wave fully polarimetric synthetic aperture radar (FMCW PolSAR) system using triangular linear frequency modulation (LFM). Our proposed system shows the first utilizations of triangular LFM for a FMCW PolSAR. The proposed signal processing algorithm is based on the range Doppler algorithm (RDA). We developed a FMCW PolSAR system that transmits triangular LFM signals, which are used less frequently than sawtooth LFM in a SAR sensor. Using a theoretical background, we describe its configuration and how it works. We propose the novel processing solution, which forms two kinds of single-polarization images from a raw data set and is suitable for our system. We obtained all four kinds of single-polarization images from two raw data sets while using the triangular LFM. In comparison, when using sawtooth LFM, we obtained the four images from four raw data sets by repeating the RDA four times. The proposed method simplifies the FMCW PolSAR system configuration, and the processing algorithm. We collected FMCW PolSAR raw data from an experimentally equipped automobile while maintaining a constant speed on a highway. The proposed algorithm and system were validated by processing a high-resolution FMCW PolSAR image.
This paper presents a pulse radar system to detect drones based on a target fluctuation model, specifically the Swerling target model. Because drones are small atypical objects and are mainly composed of non‐conducting materials, their radar cross‐section value is low and fluctuating. Therefore, determining the target fluctuation model and applying a proper integration method are important. The proposed system is herein experimentally verified and the results are discussed. A prototype design of the pulse radar system is based on radar equations. It adopts three different pulse modes and a coherent pulse integration to ensure a high signal‐to‐noise ratio. Outdoor measurements are performed with a prototype radar system to detect Doppler frequencies from both the drone frame and blades. The results indicate that the drone frame and blades are detected within an instrumental maximum range. Additionally, the results show that the drone's frame and blades are close to the Swerling 3 and 4 target models, respectively. By the analysis of the Swerling target models, proper integration methods for detecting drones are verified and can thus contribute to increasing in detectability.