The aim of this research is an evaluation of polyelectrolytes. In the application of zinc-iodine batteries (ZIBs), polyelectrolytes have high stability, good cationic exchange properties and high ionic conductivity. Polyelectrolytes are also cost-effective. Important component of ZIBs are cation exchange membranes (CEMs). CEMs prevent the crossover of iodine and polyiodide from zinc (Zn) electrodes. However, available CEMs are costly and have limited ionic conductivity at room temperature. CEMs are low-cost, have high stability and good cationic exchange properties. Herein, polyelectrolyte membranes prepared from carboxymethyl cellulose (CMC) and polyvinyl alcohol (PVA) are examined. It is seen that an increase in the ratio of PVA leads to enhanced ionic conductivity as well as increased iodine and polyiodide crossover. ZIBs using polyelectrolytes having 75:25 wt.% CMC/PVA and 50:50 wt.% CMC/PVA show decent performance and cycling stability. Due to their low-cost and other salient features, CMC/PVA polyelectrolytes prove they have the capacity for use as cation exchange separators in ZIBs.
1 January 2023 in Materials Science for Energy Technologies
The introduction of NH4OAc forms an NH4+ electrostatic layer to prevent zinc dendrite growth, while OAc− ions buffer pH, reducing corrosion and competing with water molecules to regulate the Zn/electrolyte interface.
Despite such assets as intrinsic safety and low cost, the performance of zinc‐ion batteries (ZIBs) is hindered by interfacial processes that occur at the cathode. Because of capacity fading and poor rate capability, manganese dioxide (MnO 2 ) cathodes are also negatively affected. Here, the novel application of in situ grazing incidence x‐ray absorption spectroscopy (GI‐XAS) to investigate the cathode‐electrolyte interfacial dynamics in a MnO 2 cathode ZIB is demonstrated. By using a low‐incidence angle X‐ray beam to selectively probe the cathode surface, in situ changes are captured in the MnO 2 oxidation state and local structure during charge–discharge. Results reveal that MnO 2 undergoes a dissolution‐redeposition mechanism at the interface. During discharge, Mn 4+ is reduced to Mn 3+ and further to Mn 2+ species that migrate into the electrolyte. Whilst charging, these Mn 2+ species form a transient Mn 2+ ‐rich layer on the cathode surface. This surface layer impedes Zn 2+ transport and causes increased overpotential, correlating with capacity decay. Such interfacial transformations are fully reversible in the bulk of the cathode but only partially reversible at the surface, thus leading to residual Mn 2+ / Mn 3+ species after recharge. The findings provide direct evidence of cathode surface reconstruction as a potent contributor to performance degradation.
25 August 2026 in Journal of Materials Chemistry A
Sodium battery durability is governed more by coordination-controlled interfacial resistance evolution than by bulk ionic conductivity, enabling cross-class CTI design rules for liquid, solid, and hybrid electrolytes.