10 September 2024 in IEEE Photonics Technology Letters
A novel structure of a single-photon avalanche diode (SPAD) fabricated in a commercial $\boldsymbol {180}$ nm high-voltage (HV) complementary metal-oxide-semiconductor (CMOS) process is presented. Device performance in terms of dark count rate (DCR) and photon detection probability (PDP) is compared to a previously published design fabricated as a reference on the same die. We find that the new structure exhibits a DCR of $\boldsymbol {0.11}$ Hz/ $\boldsymbol {\mu }$ m $\boldsymbol {^{2}}$ at an excess voltage of $\boldsymbol {5}$ V, which is among the lowest ever reported in a foundry CMOS process, and more than $\boldsymbol {3}$ times lower with respect to the reference device. Moreover, the new structure shows a PDP/DCR ratio higher by up to a factor of $\boldsymbol {4.2}$ compared to the reference device. The reasons underlying the differences in DCR and PDP between the two structures are explained using technology computer-aided design (TCAD) simulations. The novel device is demonstrated as promising for the design of low-cost SPAD array imagers, particularly in low-noise applications.
1 June 2026 in IEEE Transactions on Electron Devices
Novel structures of circular single-photon avalanche diodes (SPADs) with different active junction radii (9 and $\text{4}~{\mu }$ m) have been fabricated in a commercial 180-nm high-voltage (HV) CMOS process. The devices were connected to an active quenching and recharge circuit (AQRC) fabricated in the same technology, capable of operating at excess voltages up to 20 V, and characterized in terms of dark count rate (DCR), afterpulsing probability (AP), and position-dependent photon detection probability (PDP). The device with the larger radius exhibits state-of-the-art noise performance with a DCR per unit area below 0.2 Hz/ $ {\mu }$ m $^{\text {2}}$ at $\textit {V}_{\textbf {EX}}=\text {5}$ V, but the device with the smaller radius shows a further improvement in DCR by more than a factor of 10, which clearly does not scale with area. Technology computer-aided design (TCAD) simulations have been performed to explain the differences in breakdown voltage and DCR between the two structures, and the record-low DCR of the smaller device was linked to a significant decrease in effective active area, caused by the electric field decrease due to charge sharing between the explicit guard ring (GR) and the multiplication region, as confirmed by position-dependent PDP measurements over the entire device. Nevertheless, it is demonstrated that the active area can be increased by applying a higher excess voltage while achieving a central PDP above 20% at a wavelength of 635 nm, making the device an attractive candidate for ultralow-noise applications where a high fill factor is not a critical requirement.