30 September 2022 in Sensors and Actuators B: Chemical
6 January 2023 in IEEE Transactions on Microwave Theory and Techniques
A new efficient synthesis method of angular selective surfaces (ASSs) based on the accurate equivalent circuit model is proposed. The angular dispersion of different components under oblique incidence is modeled by virtual lumped elements in the angular domain. The processes of obtaining the equivalent circuit for substrates, electrically small grids and patch arrays are presented in detail. The synthesized circuits are simple and accurate. Full-wave simulations are carried out to obtain the angular dispersion of different structures, and the calculated results are in good agreement with those of the equivalent circuit. A third-order ASS with bandpass response and a second-order ASS with a tunable bandwidth are given as design examples. The implemented second-order ASS shows the 0.33 to 0.52 tunable bandwidth in the angular domain. The transmission loss is better than 1.2 dB when the incidence angle is 65 $^\circ$ –77 $^\circ$ . The simulation results and calculated results are in good agreement with the measured results.
13 August 2024 in IEEE Transactions on Antennas and Propagation
At present, satellite communication has the problem of multiple communication bands and limited satellite space. Therefore, based on the shared aperture array technology, this communication proposes a shared aperture array operating in the C-/Ku-band, which solves the problem of multiple communication bands and large antenna footprint for multiple separate bands with a very wide operating frequency band and a very high aperture reuse rate. The design is based on a magnetoelectric (ME) dipole antenna, which integrates four Vivaldi antennas in the dipole arms through deformation, and a low-pass filter is designed to further improve the isolation between the C- and Ku-bands. Finally, a small antenna array is designed, with a bandwidth of 67.7% (4–8.6 GHz) for the ME dipole array and a bandwidth of 50% (12–20 GHz) for the Vivaldi antenna.
25 June 2024 in IEEE Transactions on Antennas and Propagation
This communication proposes a low-profile dual-band shared-aperture composite antenna array with Ka-band reflectarray (RA) and X-band phased array (PA). The minimal unit of the array consists of three concentric rings. As a RA unit, the reflected phase can be controlled by varying the size of the inner two rings. The outermost ring remains constant, and each minimal 4x4 units can serve as a PA unit by employing a slot-coupled feed structure. By this mean, the radiation structures of RA and PA can be constructed within a single layer of substrate. To validate this concept, an antenna prototype is designed, fabricated, and measured. The profile of the proposed antenna is 0.067 λ 0 at 9 GHz. The measured results show that the RA has a peak gain of 31.3 dBi at 28 GHz, with a corresponding aperture efficiency of 52.5%, and a -3 dB relative gain bandwidth of 18% (24.8 to 29.7 GHz). The PA achieves a gain of 20.87 dBi (9 GHz), and the relative bandwidth is 16.35% (8.42 to 9.92 GHz) when scanned in the boresight direction. The gain loss during the scan at 45 degrees on the E/H planes is 2.0 dB and 1.72 dB, respectively.
25 August 2022 in IEEE Antennas and Wireless Propagation Letters
A dual-polarized frequency selective absorber (FSA) with dual notch bands is proposed in this letter, in which the lower notch-band and upper notch-band can be adjusted independently and mechanically. The proposed design is a dual-layer structure consisting of two dielectric substrates with etched metal patterns, separated by an air layer in the middle. A bowtie-shaped metal array on the top layer provides broadband absorption. The dual-band-notched with high design freedom property is achieved by dual square loops (DSLs) with parasitic L-shaped elements on the bottom layer and the U-slot etched on the bow-tie-shaped metal pattern. A prototype of FSA exhibits good absorption from 4.58 to 6.8 GHz, 8.52 to 12.5 GHz, and 13.73 to 15.15 GHz, whereas two typical reflective bands are obtained from 7.11 to 7.66 GHz and 12.95 to 13.59 GHz. The center notch-frequency tunable range is from 6.88 to 7.78 GHz and 12.05 to 13.36 GHz, for the lower and upper notch, respectively. Furthermore, an equivalent circuit model (ECM) is presented. Good agreement is obtained among simulation results, circuit analysis, and final measured response.
22 April 2014 in Japanese Journal of Applied Physics