1 January 2024 in Physics of Fluids
In high-pressure pulsatile pipeline transport of high-concentration viscous paste, severe backflow is generated when there are sudden pressure drops due to the paste's elastic recovery, resulting in strong impact and damage to the pipeline system. The paste demonstrates high viscosity, yield stress, compressibility, and shear elasticity. Nevertheless, the effect of the paste's elastoviscoplasticity properties on unsteady flow during pipeline transport remains uncertain. Consequently, we derived the unsteady flow control equations of the paste that accounts for the elastoviscoplasticity behavior and linear compressibility. We conducted experimental research by building a circulating pipeline transportation system and performed numerical analysis using the finite-volume method (modified RheoFoam solver). The results demonstrate a substantial increase in pressure fluctuations within the pipeline during rapid pressure drops due to the elasticity of the paste. When accounting for elasticity, the maximum backflow velocity increases by 32.4% compared to cases where elasticity is not considered. The backflow velocity during piston pump reversal is influenced by the pressure level and the rate of pressure drop. Pressure fluctuations are more likely to propagate along the pipeline during high-pressure than during low-pressure periods. These findings offer guidance for analyzing unsteady flow characteristics in paste pipeline transport and designing pipeline systems.
1 January 2021 in Shock and Vibration
A multiparameter control strategy and method for the cutting arm of a roadheader is proposed through the operation analysis of roadheader. The method can address the problems of low intelligence and low cutting efficiency faced by the roadheader in the cutting process. The control strategy is divided into two parts: the cutting load identification part and the swing speed control part. The former part is designed using a backpropagation neural network that is optimized by an improved particle swarm optimization algorithm. The latter part is optimally designed using a fuzzy PID controller with improved simulated annealing particle swarm optimization. The simulation analysis in SIMULINK showed that the response time was reduced, proving the robustness of the method. In addition, experimental studies verified the good control effect of the method under different cutting states. The proposed method uses multiparameter to intelligently change the swing speed, providing a theoretical and practical basis for the realization of intelligent and unmanned cutting of roadheader.
4 February 2026 in Journal of the Energy Institute
1 February 2026 in Physics of Fluids
The dripping behavior of high-concentration viscous solid waste entering a boiler directly affects combustion efficiency and operational stability. This study investigates droplet formation through a combined experimental and computational approach. A recirculating pipeline system with adjustable outlet diameters and discharge velocities was constructed, and a two-phase volume of fluid model incorporating a Herschel–Bulkley constitutive law was implemented to simulate the transient dripping process. Using high-concentration coal slime as a representative viscoplastic material, the simulations accurately reproduce the experimentally observed necking evolution and final droplet geometry, with length deviations of approximately 3.2%. Results show that the droplet formation interval decreases sharply with increasing velocity and follows a shifted inverse relationship. As the velocity increases, droplet morphology transitions from short and wide to elongated and slender due to two coupled mechanisms: (i) stretching induced by the preceding droplet and (ii) a downward migration of the pinch-off location that keeps the slime near the outlet in a yielded state immediately after detachment. Consequently, the difference between the initial droplet and subsequent steady-state droplets increases with velocity. The effect of pipe diameter on the droplet formation interval is negligible, with variations within 5%. However, at a fixed flow velocity, larger diameters produce greater reductions in maximum droplet diameter due to the formation of an extended tapered yielding zone near the droplet tip. This study provides a validated numerical framework and mechanistic insight into the dripping behavior of yield-stress slurries, offering predictive capability for engineering slime-feeding systems.