Meteorological normalization refers to the removal of meteorological effects on air pollutant concentrations for evaluating emission changes. There currently exist various meteorological normalization methods, yielding inconsistent results. This study aims to identify the state-of-the-art method of meteorological normalization for characterizing the spatiotemporal variation of NOx emissions caused by the COVID-19 pandemic in China. We obtained the hourly data of NO2 concentrations and meteorological conditions for 337 cities in China from January 1, 2019, to December 31, 2020. Three random-forest based meteorological normalization methods were compared, including (1) the method that only resamples meteorological variables, (2) the method that resamples meteorological and temporal variables, and (3) the method that does not need resampling, denoted as Resample-M, Resample-M&T, and Resample-None, respectively. The comparison results show that Resample-M&T considerably underestimated the emission reduction of NOx during the lockdowns, Resample-None generates widely fluctuating estimates that blur the emission recovery trend during work resumption, and Resample-M clearly delineates the emission changes over the entire period. Based on the Resample-M results, the maximum emission reduction occurred during January to February 2020, for most cities, with an average decrease of 19.1 ± 9.4% compared to 2019. During April of 2020 when work resumption initiated to the end of 2020, the emissions rapidly bounced back for most cities, with an average increase of 12.6 ± 15.8% relative to those during the strict lockdowns. Consequently, we recommend using Resample-M for meteorological normalization, and the normalized NO2 concentration dynamics for each city provide important implications for future emission reduction.
In robotics, the tough problem about the dynamic target capturing consists of tracking the target by the robot manipulator and grasping the target by the robot finger. For the sake of space, this article deals with only the first problem, tracking the dynamic target by the robot manipulator. The traditional approaches of capturing the dynamic target may work well when they are employed in low-dimensional space by reinforcement learning or physical modeling. However, they fail to work well in high-dimensional space. The traditional approaches have four limitations with respect to Cartesian space, configuration space, reinforcement learning, and physical modeling. To overcome these limitations, this article implements improved dynamic A* algorithm in high-dimensional configuration space map to capture the target. First, a space injection model injects the collision detection and target position from the Cartesian space into the configuration space to construct a high-dimensional map. Then, the target capturing method including the improved dynamic A* algorithm is applied on the map to track and capture the target. Finally, the experiment performed in time-varying environment and the dynamic target achieves a reliable result. This article has proposed an approach that makes the robot manipulator motion planning more accurate in high-dimensional dynamic configuration space. This approach enables the multi-joint manipulator to avoid the obstacle while tracking the target in high-dimensional configuration space. It takes the advantages of heuristic algorithms in the process of target capturing method designing. It adds precision and speed to target tracking. The success of the approach may apply to any industrial robot tracking target, surgical operation, and space probes. And, it may lay a solid foundation for dynamics control with a scope for future investigations.