The objective of the presented research was to determine the influence of cellulose coating, obtained from the cellulose solution in N-Methylmorpholine N-oxide (NMMO), on the structural and mechanical properties of paper. The effect of heating time of paper samples coated with cellulose dissolved in NMMO was also investigated. Depending on the heating time of the coating, a continuous or porous layer was obtained. Coating without any heating stage yielded a continuous cellulose layer of hydrophobic properties (higher contact angle in comparison to base paper), and paper of higher smoothness and increased tear resistance. Analysis of the paper samples showed that cellulose coating not only changed the surface properties of paper, but also significantly improved paper strength properties, such as the tensile index, elongation, bursting strength index and double folds number. Despite the process’ limitations (e.g. necessity of removing the NMMO), this method can be considered as a novel approach for paper property modification.
Cellulose fines are—in general—small particles removed from natural cellulose fibres during refining process which is typically carried out in papermaking industry. Fines have been recognized as a separate component of papermaking fibrous raw material since their properties differ considerably from those of cellulosic fibres. Fines are characterized by low dewatering ability, very high specific surface area, and high swelling ability. Knowledge about the possibility of effective control over fines generation and swelling during refining process are nowadays of key importance. Beside its significance in papermaking process (e.g. impact on paper structure and mechanical properties and dewatering properties of the pulp), nowadays the cellulose fines fraction is considered as a raw material for the production of novel materials e.g. microfibrilled cellulose and nanocellulose. The main objective of the presented study was to determine the impact of the most important refining parameters (e.g. net refining energy, rotor speed, and pulp consistency) which could be used to control the fines development and their swelling degree. On the basis of presented research results it may be concluded that the amount of the fines generated during refining process was mainly affected by the effective refining power (net power) and the rotational speed of the refiner rotor. Also, the final swelling degree of fines varies depending on the refining operating conditions used. It was found that the swelling degree of fines was mostly influenced by the rotational speed of the refiner rotor, refined pulp consistency, and—for very low consistency (1–2%)—also pulp volumetric flow rate through the refiner. As a result, it could be concluded that—for more effective control of the refining process—greater attention to the control of these parameters should be paid.
This paper discusses the possibility of nanofibre formation in an electrostatic field from cellulose solutions in different solvent systems. Additionally when investigating solutions of various cellulose content, an attempt was made to evaluate these solutions from the viewpoint of their usability for nanofibre formation. The spinnability of the solutions examined was assessed based on observation of the stability of nanofibre formation by the simplest single needle spinning device. The morphology of the samples obtained by electrospinning was studied by Scanning Electron Microscopy (SEM). Spinning dopes were obtained using well-known technologies for cellulose solution preparation applied in the cellulose fibre industry, namely N-Methylmorpholine N-oxide (NMMO) and viscose methods, as well as a mixture of phosphoric acids, which is relatively cheap, easily available and yet not used in industry. Based on the research conducted, it may be concluded that the cellulose solutions in NMMO proved to be the best system for exceptionally stable formation of nanofibres in an electrostatic field.