Muhammad Yaqoob

Muhammad Yaqoob

Auto-generated profile, based on publicly available information

Muhammad Yaqoob

Department of Electronic and Information Engineering, Hong Kong Polytechnic University, 26680 Kowloon, Select Hong Kong

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 August 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
MYMuhammad Yaqoob
Muhammad Yaqoob
KLKa Hong Loo
Ka Hong Loo
YLYuk Ming Lai
Yuk Ming Lai
This paper proposes a four-degrees-of-freedom (4-DOF) modulation scheme to mitigate conduction and switching loss in dual-active-bridge (DAB) series-resonant converter. Under wide-range variations in voltage gain and output current, increased reactive power and root-mean-square (rms) tank current can contribute significantly to conduction loss in DAB converter while the occurrence of hard switching leads to switching loss and increased device stress. The proposed modulation scheme utilizes internal, external phase shifts, and switching frequency as modulation parameters to achieve zero reactive power, minimum-tank-current and complete soft-switching operation. Analysis of the proposed modulation scheme is given for both buck and boost-mode operation. The proposed modulation scheme is validated by means of a 1-kW experimental prototype of DAB series-resonant converter operating at 100 kHz designed to interface a super-capacitor with a rated output voltage of 48 V to a 250-V dc bus. The effectiveness of the proposed topology for charging/discharging a super-capacitor under wide-range variations in voltage gain and output current is verified by simulations and experimental results. A maximum efficiency of 97.6 % is recorded from experimental prototype.

17 January 2017 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
MYM. Yaqoob
M. Yaqoob
KLKa Hong Loo
Ka Hong Loo
YLY. M. Lai
Y. M. Lai
Hard-switching-induced switching loss can contribute significantly to the power loss of an isolated bidirectional dual-active-bridge (DAB) dc-dc converter operating at high frequency. An LC-type series resonant DAB converter based on a switch-controlled-inductor (SCI) is proposed to mitigate the loss arising from hard switching under wide-range variations in output voltage and current. Zero-voltage switching is achieved at the primary side (high voltage), while at the secondary side (low voltage), zero-current switching is preferred to reduce excessive ringing due to circulating current and switching loss. In order to achieve reduced conduction loss, a nominal operating point is chosen where the root-mean-square resonant tank current is the minimum. To validate the proposed topology and modulation scheme, an LC-type series resonant DAB converter based on SCI operating at 100 kHz is designed to interface a 400-V dc bus to a supercapacitor-based energy storage. Simulation and experimental results validate the effectiveness of the proposed topology for charging/discharging a supercapacitor with an output voltage variation of between 10 and 48 V and a maximum rated power of 480 W. A maximum efficiency of 94.6% is achieved using the proposed topology and modulation scheme.

23 January 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
MYMuhammad Yaqoob
Muhammad Yaqoob
KLKa Hong Loo
Ka Hong Loo
YLYuk Ming Lai
Yuk Ming Lai
Both conduction loss and switching loss can contribute significantly to the overall power loss of an isolated bidirectional dual-active-bridge series-resonant dc-dc converter (DABSRC) operating at high frequency. To achieve soft switching and minimum-tank-current operation under wide-range variations in output voltage and current, a switched-impedance-based DABSRC is proposed. Minimum-tank-current operation aims to reduce conduction loss arising from circulating current at the low voltage, high-current side of DABSRC. Full-range soft switching is achieved in all switches, thus, switching loss is significantly reduced. With this new topology, power control is achieved by controlling a switch-controlled capacitor in the series resonant tank while ensuring minimum-tank-current operation and soft switching in all switches. The proposed topology and modulation scheme are validated by means of a 1-kW experimental prototype of DABSRC operating at 100 kHz designed to interface a 250-V dc bus to a supercapacitor with a rated output voltage of 48 V. The effectiveness of the proposed topology for charging/discharging a supercapacitor at a maximum rated power of 1 kW is verified by simulations and experimental results with a maximum efficiency of 97.5%.

12 November 2018 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
MAMajid Ali
Majid Ali
MYMuhammad Yaqoob
Muhammad Yaqoob
LCLingling Cao
Lingling Cao
KLKa Hong Loo
Ka Hong Loo
Two-stage single-phase inverter system has found many applications in distributed generators and grid-connected systems. However, the existence of double-line frequency ripple on the dc-bus voltage due to single-phase inverter's operation has given rise to some design and reliability issues. Some of these are the degradation in the quality of inverter's output voltage and shortening of dc-bus capacitor's lifetime. The problem is rooted in the controller design of the front-end dc-dc converter, which is often designed based on a simplified mathematical model of the dc-dc converter that fails to account for some complex phenomena, such as system's nonlinearities and circuit parameter variations due to temperature and aging effects. In this paper, a disturbance-observer-based control is proposed where these unmodeled effects are treated in the form of lumped disturbance and compensated for in a feed-forward manner. The major advantage of this control solution is that only minimal plant information is needed for controller design and that a decoupled composite controller can be realized, where the feedback compensator is designed to meet certain stability criteria while the disturbance-observer-based feed-forward compensator is designed to handle fast transient events. A prototype of a dual-active-bridge (DAB) dc-dc converter implemented with disturbance-observer-based control is constructed to verify its effectiveness. Experimental results show that the dynamic response of the DAB converter is significantly improved and the double-line frequency ripple on the dc-bus voltage is effectively suppressed by the proposed control solution.

3 August 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
YCYiu Pang Chan
Yiu Pang Chan
KLKa Hong Loo
Ka Hong Loo
MYMuhammad Yaqoob
Muhammad Yaqoob
YLY. M. Lai
Y. M. Lai
This paper proposes a reconfigurable dual-active-bridge (DAB) converter which is capable of switching between two converter structures for enhancing its performances at different output power levels. For 50% to 100% load, the converter operates in full-bridge mode and achieves soft-switching in all switches independently of the input-to-output voltage ratio. Below 50% load, the converter is reconfigured to operate in half-bridge mode for reduced circulating current and improved light-load efficiency while maintaining the desired soft-switching characteristic of full-bridge mode. The achievement of soft-switching is aided by the use of a tuned LCL resonant tank which enables an accurate prediction of the phases of tank currents with respect to tank voltages, and therefore simplifies the realization of soft-switching. The effects of dead time are discussed and expressions for guiding the selection of appropriate dead time for ensuring soft-switching in practical implementation are derived. The proposed converter and modulation scheme are experimentally verified with a 1.6-kW converter prototype which demonstrates their merits in comparison with a non-reconfigurable, full-bridge DAB topology and conventional modulation schemes.

1 July 2019 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
YCY. P. Chan
Y. P. Chan
MYM. Yaqoob
M. Yaqoob
CWC. S. Wong
C. S. Wong
KLKa Hong Loo
Ka Hong Loo
Efficiency optimization of dual active bridge (DAB) converter involves the minimization of both conduction and switching losses. However, it is challenging to achieve these two objectives simultaneously due to their conflicting nature, i.e. circulating current is required to realize zero-voltage switching (ZVS) but the presence of an excessive amount of circulating current is the main cause of conduction loss and low efficiency. This dilemma has been common to conventional DAB converter topologies and modulation schemes which cannot provide sufficient degrees of freedom (DoF) to the design of their operation modes. This work is an illustration of the merits of utilizing reconfigurability of operation mode as a new DoF in designing the operation of DAB converter to minimize both conduction and switching losses. The proposed DAB converter is designed to switch between two operation modes. For 25% to 100% of the rated output power, a new modulation scheme based on four-level ac voltages is proposed to achieve zero circulating current, zero backflow power, and full-range ZVS. Below 25% of the rated output power, the new modulation scheme transitions smoothly to the Enhanced Dual-Phase-Shift (EDPS) modulation scheme which continues to achieve zero backflow power and full-range ZVS while the incurred circulating current is moderated by operating the ac voltages at half amplitude. Experimental results obtained from a 2-kW prototype show that, in comparison to conventional modulation schemes, the proposed modulation scheme is capable of maintaining the highest efficiency over the full output power range and greatly improves the reliability of switches due to full-range ZVS operation.