An electrochemical setup was designed and built to evaluate carbon dioxide solubility in ionic liquids. The setup can simultaneously measure amounts of CO2 in the gas and in the ionic liquid phase, making it very useful for in situ electrochemical measurements. The home-built glass cell is able to withstand high vacuum allowing the ionic liquid samples to be properly evacuated before characterization and kept free of contaminants during experiments. A pressure gauge attached to the setup enables continuous monitoring of gas added to the system. This kind of configuration can measure gas solubility in ionic liquids expressed as Henry’s constants determined from generated plots of dissolved gas concentration in the ionic liquid vs headspace gas pressure. It also serves as a more economical alternative to other gas solubility measurement techniques, as it is predominantly made of glass, and requires minimal sample amounts. The setup can be useful in determining the solubility of various gases in ionic liquids.
The wavelength-dependent photo-reactivity of polyanthracene was explored upon UV-C and VIS light irradiation. The material was prepared via one-pot chemical oxidation route using FeCl3 as oxidizing agent. A decrease in surface hydrophobicity of a polyanthracene-coated poly(methylmethacrylate) substrate from 109.11° to 60.82° was observed upon UV-C exposure for 48 hrs which was attributed to increase in oxygen content at the surface, as validated by energy dispersive X-ray spectroscopy. Upon exposure to ultraviolet-visible LEDs, photo-dimerization of polyanthracene in solution occurred and was monitored using UV-VIS spectroscopy. The photo-dimer product formation decreased from 381 nm to 468 nm and was found to be higher for the polyanthracene material compared to the monomer anthracene. At 381 nm, photo-dimerization of the material was found to be approx. 4x more efficient than the non-substituted monomer counterpart. Results obtained show that photo-dimerization of polyanthracene will proceed upon exposure with visible light LEDs with reduction in efficiency at longer wavelengths. To compensate, irradiation power of the light source and irradiation time were increased.