9 November 2021 in Journal of Applied Physics
We investigate experimentally the effects of strain on the injection of 180 domain walls (DWs) from a nucleation pad into magnetic nanowires, as typically used for DW-based sensors. In our study, the strain, generated by substrate bending, induces in the material a uniaxial anisotropy due to magnetoelastic coupling. To compare the strain effects, , Ni, and samples with in-plane magnetization and different magnetoelastic coupling are deposited. In these samples, we measure the magnetic field required for the injection of a DW, by imaging using differential contrast in a magneto-optical Kerr microscope. We find that strain increases the DW injection field and that the switching mechanism depends strongly on the strain direction. We observe that low magnetic anisotropy facilitates the creation of a domain wall at the junction between the pad and the wire, whereas a strain-induced magnetic easy axis significantly increases the coercive field of the nucleation pad. Moreover, we find that these effects of strain-induced anisotropy can be counteracted by an additional magnetic uniaxial anisotropy perpendicular to the strain-induced easy axis. We perform micromagnetic simulations to support the interpretation of our experimental findings showing that the above described observations can be explained by the effective anisotropy in the device. The anisotropy influences the switching mechanism in the nucleation pad as well as the pinning of the DW at the wire entrance. As the DW injection is a key operation for sensor performances, the observations show that strain is imposing a lower limit for the sensor field operating window.
31 October 2022 in Applied Physics Letters
This study reports the effects of post-growth He+ irradiation on the magneto-elastic properties of a Ni/Fe multi-layered stack. The progressive intermixing caused by He+ irradiation at the interfaces of the multilayer allows us to tune the saturation magnetostriction value with increasing He+ fluences and even to induce a reversal of the sign of the magnetostrictive effect. Additionally, the critical fluence at which the absolute value of the magnetostriction is dramatically reduced is identified. Therefore, insensitivity to strain of the magnetic stack is nearly reached, as required for many applications. All the above-mentioned effects are attributed to the combination of the negative saturation magnetostriction of sputtered Ni and Fe layers and the positive magnetostriction of the NixFe1−x alloy at the intermixed interfaces, whose contribution is gradually increased with irradiation. Importantly, the irradiation does not alter the layer polycrystalline structure, confirming that post-growth He+ ion irradiation is an excellent tool to tune the magneto-elastic properties of multilayer samples. An alternative class of spintronic devices can be envisioned with a material treatment able to arbitrary change the magnetostriction with ion-induced “magnetic patterning.”
5 July 2023 in Physical Review Applied
Permalloy, despite being a widely used soft magnetic material, still requires optimization in terms of magnetic softness and magnetostriction for its use in magnetoresistive-sensor applications. Conventional annealing methods are often insufficient to locally achieve the desired properties for a narrow parameter range. In this study, we report a significant improvement in the magnetic softness and magnetostriction in a 30-nm permalloy film after irradiation. The irradiation treatment reduces the induced anisotropy by a factor of 10 and the hard-axis coercivity by a factor of 5 compared with the values in the as-deposited state. In addition, the effective magnetostriction of the film is significantly reduced by a factor ten (below ) after irradiation. All the above-mentioned effects can be attributed to the isotropic crystallite growth of the alloy and to the intermixing at the magnetic layer interfaces under light-ion irradiation. We support our findings with X-ray-diffraction analysis of the textured alloy. Importantly, the sizable magnetoresistance is preserved after the irradiation. Our results show that compared with traditional annealing methods, the use of irradiation leads to significant improvements in the magnetic softness and reduces strain cross-sensitivity in permalloy films required for 3D positioning and compass applications. These improvements, in combination with the local nature of the irradiation process, make our findings valuable for the optimization of monolithic integrated sensors, where classic annealing methods cannot be applied due to complex interplay within the components in the device.
10 July 2023 in Applied Physics Letters
In this work, we propose and evaluate an inexpensive and CMOS-compatible method to locally apply strain on a Si/SiOx substrate. Due to high growth temperatures and different thermal expansion coefficients, a SiN passivation layer exerts a compressive stress when deposited on a commercial silicon wafer. Removing selected areas of the passivation layer alters the strain on the micrometer range, leading to changes in the local magnetic anisotropy of a magnetic material through magnetoelastic interactions. Using Kerr microscopy, we experimentally demonstrate how the magnetoelastic energy landscape, created by a pair of openings, enables in a magnetic nanowire the creation of pinning sites for in-plane vortex walls that propagate in a magnetic racetrack. We report substantial pinning fields up to 15 mT for device-relevant ferromagnetic materials with positive magnetostriction. We support our experimental results with finite element simulations for the induced strain, micromagnetic simulations, and 1D model calculations using the realistic strain profile to identify the depinning mechanism. All the observations above are due to the magnetoelastic energy contribution in the system, which creates local energy minima for the domain wall at the desired location. By controlling domain walls with strain, we realize the prototype of a true power-on magnetic sensor that can measure discrete magnetic fields or Oersted currents. This utilizes a technology that does not require piezoelectric substrates or high-resolution lithography, thus enabling wafer-level production.
7 July 2023 in Journal of Applied Physics
Synthetic ferrimagnets are an attractive material class for spintronics as they provide access to all-optical switching of magnetization and, at the same time, allow for ultrafast domain wall motion at angular momentum compensation. In this work, we systematically study the effects of strain on the perpendicular magnetic anisotropy and magnetization compensation of Co/Gd and Co/Gd/Co/Gd synthetic ferrimagnets. First, the spin reorientation transition of a bilayer system is investigated in wedge type samples, where we report an increase in the perpendicular magnetic anisotropy in the presence of in-plane strain. Using a model for magnetostatics and spin reorientation transition in this type of system, we confirm that the observed changes in anisotropy field are mainly due to the Co magnetoelastic anisotropy. Second, the magnetization compensation of a quadlayer is studied. We find that magnetization compensation of this synthetic ferrimagnetic system is not altered by external strain. This confirms the resilience of this material system against strain that may be induced during the integration process, making Co/Gd ferrimagnets suitable candidates for spintronics applications.