24 June 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
A high-speed and low energy-consuming SRAM design based on single-ended cells is demonstrated in this work. To resolve poor SNM (static noise margin) of prior single-ended memory cells, the proposed SRAM cell is equipped with a pull-up PMOS and a high-Vthn NMOS foot switch such that the cell state is not bothered by noise when the supply voltage is getting lowered. Moreover, a PFOS (Positive Feedback Op-Amp Sensing) circuit is added between bitlines ( BL̅, BL) to reduce the read delay and generate full-swing output. Last but not least, a voltage mode select (VMS) circuit is added to each column to reduce the static power of unselected cells such that idle power is drastically reduced. The reason is that the a lower voltage able to keep the state of bits is applied to those unselected cells. A 1-kb SRAM prototype based on the proposed cells with BIST (build-in self test) circuit is physically fabricated using typical 40-nm CMOS logic process. The maximum operating clock rate is 200 MHz. The energy/access and energy/bit are measured on silicon to be 0.2313 pJ, and 0.00723 pJ, respectively.
21 July 2022 in IEEE Transactions on Circuits and Systems I: Regular Papers
This investigation presents a digital logic accelerator (DLA) design of a neural network hardware that utilizes output reuse. The DLA is used in the detection mechanism of underwater objects that was deployed in an underwater vehicle. A modified YoloV3-tiny network was also implemented to detect more than 20 underwater objects. The proposed DLA uses processing units that have parallel architectures of output windows, and output channels. Moreover, a new Inter-Controller is designed to control the direct memory access (DMA) together with a new Reshape module to improve the performance and power efficiency. A detailed description of the design as well as the measurements on silicon are presented. The chip is realized using a typical 180-nm CMOS process. It showed a performance result of 40.96 GOPS and the power consumption is 196.8 mW. The DLA was tested to demonstrate 19.88 frames per second and 40.96 GOPS.