1 December 2015 in Biomaterials
1 February 2017 in Biosensors and Bioelectronics
18 November 2015 in RSC Advances
Droplet microfluidic-based cell screening has the potential to surpass time- and cost efficiency of established screening platforms by several orders of magnitude, but so far lacks sufficient and homogeneous oxygen supply for large droplet numbers (>106), which is a key parameter affecting metabolism and growth of encapsulated cells. Here, we describe and validate an approach based on continuous carrier oil recirculation that ensures enhanced and homogeneous oxygen availability during mid and long-term incubation of picoliter droplets retained in a 3D-printed storage device. Using biotechnologically relevant microorganisms, we demonstrate that improved oxygen transfer results in three to eleven-fold increased biomass and highly elevated protein production with minimal inter-droplet variation. In fact, obtained yields are comparable to those achieved in conventional cultivation devices, so that screening strategies commonly applied in microtiter plates or shaking flasks can now be scaled down to pL-droplets, which offer highly enhanced throughput. In contrast to mere single-cell screening, this approach allows monoclonal cell and metabolite accumulation inside droplets resulting in elevated read-out signals and reduced variability associated to stochasticity in gene expression. Additionally, the range of screening strategies is broadened, since screening for increased biomass yields or mining for microbial natural products from complex environmental samples can now be targeted with pL-droplets. This development substantially improves the robustness and versatility of droplet-based cell assays, further consolidating pL-droplets as a powerful ultrahigh-throughput experimentation platform.
21 September 2014 in Analytical Chemistry
Arsenic-containing lipids (arsenolipids) are novel natural products recently shown to be widespread in marine animals and algae. Research interest in these arsenic compounds lies in their possible role in the membrane chemistry of organisms and, because they occur in many popular seafoods, their human metabolism and toxicology. Progress has been restricted, however, by the lack of standard arsenolipids and of a quantitative method for their analysis. We report that the certified reference material CRM 7405-a (Hijiki) is a rich source of arsenolipids, and we describe a method based on HPLC-ICPMS/ESMS to quantitatively measure seven of the major arsenolipids present. Sample preparation involved extraction with DCM/methanol, a cleanup step with silica, and conversion of the (oxo)arsenolipids originally present to thio analogues by brief treatment with H2S. Compared to their oxo analogues, the thioarsenolipids showed much sharper peaks on reversed-phase HPLC, which facilitated their resolution and quantification. The compounds were determined by HPLC-ICPMS and HPLC-ESMS, which provided both arsenic-selective detection and high resolution molecular mass detection of the arsenolipids. In this way, the concentrations of two arsenic-containing hydrocarbons and five arsenosugar phospholipids are reported in the CRM Hijiki. This material may serve as a convenient source of characterized arsenolipids to delineate the presence of these compounds in seafoods and to facilitate research in a new era of arsenic biochemistry.
1 June 2016 in Sensors and Actuators B: Chemical
A powerful online analysis set-up for oxygen measurements within microfluidic devices is presented. It features integration of optical oxygen sensors into microreactors, which enables contactless, accurate and inexpensive readout using commercially available oxygen meters via luminescent lifetime measurements in the frequency domain (phase shifts). The fabrication and patterning of sensor layers down to a size of 100μm in diameter is performed via automated airbrush spraying and was used for the integration into silicon-glass microreactors. A novel and easily processable sensor material is also presented and consists of a polystyrene- silicone rubber composite matrix with embedded palladium(II) or platinum(II) meso-tetra(4-fluorophenyl) tetrabenzoporphyrin (PdTPTBPF and PtTPTBPF) as oxygen sensitive dye. The resulting sensor layers have several advantages such as being excitable with red light, emitting in the near-infrared spectral region, being photostable and covering a wide oxygen concentration range. The trace oxygen sensor (PdTPTBPF) in particular shows a resolution of 0.06–0.22hPa at oxygen concentrations lower than 20hPa (<2% oxygen) and the normal range oxygen sensor (PtTPTBPF) shows a resolution of 0.2–0.6hPa at low oxygen concentrations (<50hPa) and 1–2hPa at ambient air oxygen concentrations. The sensors were integrated into different silicon-glass microreactors which were manufactured using mass production compatible processes. The obtained microreactors were applied for online monitoring of enzyme transformations, including d-alanine or d-phenylalanine oxidation by d-amino acid oxidase, and glucose oxidation by glucose oxidase
22 September 2016 in Analytical Chemistry