PtCu– and PdCu–mordenite allow for isothermal reaction at 200 °C for the stepwise methane to methanol conversion with higher yields under isothermal conditions than after high temperature activation.
Four commercial monolithic diesel oxidation catalysts (DOCs) with two different platinum group metal (PGM) loadings and Pt:Pd ratios of 1:0, 2:1, 3:1 (w/w) were investigated systematically for CO, C3H6, and NO oxidation, CO-C3H6 co-oxidation, and CO-C3H6-NO oxidation reactions via transient activity measurements in a simulated diesel engine exhaust environment. As PGM loading increased, light-off curves shifted to lower temperatures for individual and co-oxidation reactions of CO and C3H6. CO and C3H6 were observed to inhibit theoxidation of themselves and each other. Addition of Pd to Pt was found to enhance CO and C3H6 oxidation performance of the catalysts while the presence and amount of Pd was found to increase the extent of self-inhibition of NO oxidation. NO inhibited CO and C3H6 oxidation reactions while NO oxidation performance was enhanced in the presence of CO and C3H6 probably due to the occurrence of reduced Pt and Pd sites during CO and C3H6 oxidations. The optimum Pt:Pd ratio for individual and co-oxidations of CO, C3H6, and NO was found to be Pt:Pd = 3:1 (w/w) in the range of experimental conditions investigated in this study.
Kinetic modeling of NH3 Selective Catalytic Reduction (NH3-SCR) of NOx in Cu-chabazite washcoated monolithic reactors has recently become an important task for design, control and calibration of heavy-duty engine aftertreatment systems. Development of detailed and accurate kinetic models rely on the correct simulation of the NO2 and NH3 storage at different conditions. Here, different kinetic schemes for NO2 adsorption and desorption were developed and compared to experimental data. For this purpose, firstly, realistic values of the active Cu sites in the Cu-zeolite were obtained using the temperature programmed desorption (TPD) of NH3 and NO2 which showed fractional coverages of 0.04 and 0.17 for the so-called ZCuOH and Z2Cu species which reside in the 8 and 6 membered rings (MR) of the zeolitic framework, respectively. Active site concentrations were used in the kinetic models which included simultaneous formation of nitrate/nitrite species or the formation of HNO3 intermediate which in turn resulted in the formation of nitrates or nitrites over the ZCuOH. Models also included or excluded the NO2 storage over the so called secondary Z2Cu sites. It was shown that models taking into account HNO3 intermediate formation along with two NO2 storage sites were better fits to the experimental data.