In this study, in order to observe the effect of spinning systems such as ring, rotor and vortex, and twist direction of the folded yarns on the fabric handle properties, single end yarns were produced in the same yarn count, yarn twist, and twist directions. After that, the single end yarns were folded on the same doubling machine in two twist directions of S and Z. These folded yarns were used as weft yarns in the woven fabrics. In addition to these parameters, four different weft insertion orders were tried (SSSS, ZZZZ, SSZZ, SZSZ) to be observed whether the insertion order makes any difference in the handle values of the fabrics. It was concluded from the study that handle properties of the fabrics produced with ring folded yarns are better than the ones produced with rotor and vortex folded yarns regardless of the weft insertion order. The fabrics produced with SSSS weft insertion order are the softest among all fabrics in all spinning systems. Besides, using the weft insertion order of SZSZ makes the fabric softer than SSZZ.
In this study 34 heads of Karacabey Merino sheep wools raised in various farms located around Tekirdağ province, Turkey were investigated. Physical wool properties such as fiber fineness, length, strength, elongation, and greasy fleece weight were examined. Samples were collected during the shearing of the animals. Samples from three different regions such as head-neck, middle, and back from each animal were taken. According to the fiber fineness and strength results, all investigated factors were found to be statistically important. It can be said that fibers from the rams and the back region of the animal were coarser and stronger. Accordingly, it was observed that coarser fibers (fibers from males or from sheep with age range of 0–2) have lower elongation at break values in general. Furthermore, for fiber length only the factor age was statistically significant. On the other hand, greasy fleece weight increased with the increase in animal age and it was higher for rams than that of ewes.
In this study, it was aimed to investigate the effect of pigmentation on the physical and mechanical properties of white and brown colored cashmere and yak down fibers in comparison with wool. According to experimental results, it was found that the pigmented fibers have higher diameter and length compared to their white equivalents. However, tenacity and elongation values were lower in pigmented fibers. On the other hand, it can be said that brown fibers had lower felting tendency compared to white fibers.
The objective of this study is to examine mechanical performance of double-layered woven fabrics used in car seat upholstery. For this purpose, 450 denier polyester yarns were supplied to produce double-layered woven fabrics. For the production of the fabrics, full weft connection, which is warp yarn of the top layer makes a connection with the weft yarn of the bottom layer, was used. To produce such a fabric, four different factors such as bottom layer pattern, number of interlacing warps in a unit report, number of interlacing picks per top warp and number of weft skips were investigated using Taguchi experimental design. After weaving stage, fabrics were stentered. Mechanical and physical properties of the fabrics were measured before and after stentering and the results were analysed with regard to Taguchi experimental analysis.