1 September 2023 in Physics of Fluids
The free surface condition of water-entry problems will be significantly modified by the presence of an ice sheet on the water surface. In this paper, we employ computational fluid dynamics to simulate the process of a cylinder entering a water body vertically and validate the numerical method by comparing the cavity evolution with experimental data. Four high-speed water-entry cases are considered: an ice-free water surface, an ice sheet with circular holes, and an ice sheet with minor and normal sized petal-shaped holes. The cavity evolution, flow field characteristics, and motion parameters of the projectile after entering the water are analyzed separately, and the effects of the ice sheets with holes on the typical water-entry characteristics are identified. The results show that the cavity closure mechanism shifts from surface to shallow closure, and a funnel-shaped cavity is observed below the surface when ice is present. The size of the cavity is extremely restricted, but the collapse of the cavity is delayed. The pressure and flow characteristics around the projectile are also affected by ice on the water surface, and the stability of the trajectory is enhanced by the existence of the ice sheet. Finally, the positive acceleration of the projectile triggered by high pressure at the tail of the structure is found to be much larger than that in the ice-free case.
16 October 2026 in Journal of Fluid Mechanics
The extreme impact forces encountered during the early moments of water entry are of critical concern in diverse fields, ranging from spacecraft recovery to aircraft ditching. Herein, we systematically investigate a variable damping strategy that uses an internal non-Newtonian fluid damper to regulate the transmission of impulsive loads during water entry. Through a combined experimental and theoretical approach, the dynamic response of dampers filled with shear-thinning and shear-thickening fluids is characterised. We demonstrate that the peak load transmitted to the main body can be reduced by up to 89.7 % compared to a fully rigid counterpart. A coupled dynamic model reveals that, unlike the constant viscosity characteristic of Newtonian fluids, non-Newtonian fluids provide damping responses that vary with the loading rate and regulate the transmission of impulsive loads under highly transient impact conditions. These findings elucidate how the rheology of damping fluid mediates the transmission of hydrodynamic impulse to the protected structure, providing a framework for variable damping protection systems during water entry.
29 October 2026 in Journal of Fluid Mechanics
An innovative air-layer establishment method is developed and experimentally investigated, where superhydrophobic transverse grooves are introduced to modulate localised minimal-flux ventilation. The results demonstrate that, owing to the modulation by the transverse grooves, the characteristics of multiphase flow undergo a fundamental transition from discrete bubbles to a continuous air layer. This modulation is strictly governed by both the free-stream velocity and the groove size, expressed as Reynolds number ( italic Re Subscript upper D $\textit{Re}_D$ ) and dimensionless groove size ( delta Superscript asterisk $\delta ^*$ ), respectively. With a systematic variation in italic Re Subscript upper D $\textit{Re}_D$ and delta Superscript asterisk $\delta ^*$ , the macroscopic topology of the air layer evolves through three distinct regimes: (i) continuous air layer (CAL), (ii) partial air layer (PAL) and (iii) bubble shedding (BS). The boundaries for these regimes are delineated within the regime map constructed by italic Re Subscript upper D $\textit{Re}_D$ and delta Superscript asterisk $\delta ^*$ . It is established that size effects are negligible for the CAL–PAL transition, whereas the transition from PAL to BS exhibits a pronounced dependence on delta Superscript asterisk $\delta ^*$ . The two regime transitions therefore follow distinct scaling relations. Neither transition boundary shows a discernible dependence on the solid fraction of the grooves. The dependence of regime transitions on ventilation flux is further examined, and the Weber number ( upper W e Subscript j $We_j$ ) is introduced to characterise the competition of the dynamic pressure of injected gas and the capillary force within grooves. The drag-reduction effectiveness of the groove-modulated air layers was also demonstrated. The present findings elucidate the mechanisms of air-layer establishment and provide a robust framework for the design of superhydrophobic grooved surfaces in air-layer drag-reduction applications.