This article describes the nature of bonding in hyperlithiated molecules with stoichiometries exceeding normal valence expectations. The existence of such hyperlithiated or hypervalent molecules as CLi6, Li3O, Li4O, Li5O, Li3S, Li4S, Li4P, Li2CN, Na2CN, and K2CN has already been experimentally confirmed by means of Knudsen-effusion mass spectrometry in our laboratory. These molecules have nine or more valence electrons, violating, at least formally, the octet rule. However, these molecules are thermodynamically more stable than the corresponding octet molecules. Results of ab initio MO calculations reveal that the extra valence electrons beyond the usual octet are in singly occupied orbitals (SOMO) or highest occupied orbitals (HOMO) in the LinA (A = C, O, P, S) molecules. The SOMO as well as HOMO forms the Li–Li bonds between all pairs of lithium atoms and contribute to stabilization of these molecules. The bonding situation of the M2CN (M = Li, Na, K) species is apparently different from that of LinA. The favored structure has Cs symmetry and is best described as a complex of the CN− anion with the M2+ cation. The extra valence electron is in SOMO, which corresponds to the radical cation SOMO and contributions to M–M bonding. The presence of the M2+ unit is a typical example of justifying the term hypervalent.
1 November 2004 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
Use of dry plasma etching rather than wet etching of a Cu-seed layer in a semi-additive process enabled more precise dimension controllability in the patterning of submicron-scale Cu traces due to no shift in the width of the traces. This controllability is comparable to that of competitive fabrication technologies such as that for damascene-based Cu redistribution layers. The dry etching enabled the patterning of Cu traces with an aspect ratio as high as 4.2 (L/S=0.7/0.7 µm, 3.0 µm in height) without any failures such as electrical shorts between traces. Simulation showed that an increase in the aspect ratio effectively reduced signal transmission loss due to a reduction in conductor loss. The dry etching provided very smooth surfaces on the Cu-trace side-wall (roughness as low as 0.05 µm). This further reduced the signal transmission loss compared to that of wet-etched Cu traces. Submicron-scale patterning of Cu traces using dry etching enables flexible design of redistribution layer lines in terms of signal integrity, in addition to increasing the number of signal I/Os cost effectively.
1 May 1992 in International Journal of Radiation Applications and Instrumentation. Part A. Applied Radiation and Isotopes