At present, there are many works on the influences of partially hydrolyzed polyacrylamide (HPAM) and surfactant on the stability and treatment of O/W emulsion produced by surfactant-polymer (SP) flooding. However, there are few related reports on the effects of HPAM and surfactant on the demulsification of W/O crude oil emulsion produced by SP flooding. Especially, there is no report on the effect of the surfactant type. In this paper, sodium dodecyl sulfate (SDS), octylphenol polyoxyethylene ether (OP-10), and alkyl C16-18 hydroxypropyl sulfobetaine (HSB1618) were selected as representatives of the anionic surfactant, nonionic surfactant, and zwitterionic surfactant, respectively. Demulsification experiments and interface behavior experiments were conducted to investigate their influences on the demulsification performance of a demulsifier D1. The results showed that the order of the negative effect of the surfactant type on dehydration speed and the dehydration rate of D1 was HPAM + OP-10 > HPAM + HSB1618 > HPAM + SDS. There is no difference in the effect of three surfactants on the conformation adjustment of D1 at the W/O interface, but the properties of the composite W/O interface formed by them and D1 were different. The coalescence time was longest when there were HPAM and OP-10 in water, while the lg(G1'/Gdemulsifier')/lgG1' was the smallest, which led to the most difficult demulsification of W/O emulsion. This work can guide surfactant selection during SP flooding from the perspective of produced fluid treatment.
In this paper, first, the effects of four polymers, including partially hydrolyzed polyacrylamide (HPAM), hydrophobically modified polyacrylamide (HMPAM), surface-active polymer (SAP), and heavy oil activator (HOA), on the stability of produced water were studied, and then, the effects of the four polymers on the performance of a nonionic polyether water clarifier AE411 were compared. The results of turbiscan stability index and heart-shaped structure microfluidic chip experiments showed that the four polymers can enhance the stability of oil droplets, ranked as SAP > HMPAM > HOA > HPAM. They can increase the absolute value of oil droplet ζ-potential, the elastic modulus of the oil–water interface, and the repulsion force between oil droplets. SAP and HMPAM significantly increased the absolute value of ζ-potential and the steric repulsion force between oil droplets, respectively, which enhanced the stability of oil droplets in produced water stronger than that of HPAM and HOA. The produced water treatment results presented that these polymers weakened the performance of AE411, and the weakening result was consistent with their impact on the stability of oil droplets. The four polymers would affect the adsorption of AE411 at the oil–water interface, thus affecting its performance of reducing the strength of the oil–water interface and generating attractive force on the oil droplets.