In this article, we compare field estimates of near‐surface attenuation, as captured by site‐specific ‐values (i.e., ) with laboratory‐based estimates of minimum shear‐strain damping (). We propose models for based on measured at selected stations of the KiK‐net database, which are found to be generally larger than low‐strain damping values obtained from laboratory testing. The latter can only quantify intrinsic material damping, whereas other attenuation mechanisms such as scattering of the wavefield contribute to field‐based estimates. In addition, we evaluate the difference in damping at the surface and at borehole stations to determine the contribution of shallow layers to attenuation as captured by ‐values at the surface. Thus, values of are computed at the surface and at the downhole instrument depth. The difference between both values, , correlates well with the averaged shear‐wave velocity over the top 30 m of the profile, , and with the depth to bedrock. Estimates of for hard‐rock and stiff sites in Japan are also examined and compared with other regional ‐values proposed for high materials in New Zealand, Greece, and Switzerland. Two values of , which are lower than the corresponding estimates for the aforementioned regions, are deemed potential descriptors of hard‐rock conditions in Japan. The ability of the proposed ‐consistent damping models to predict ground motions using the vertical array data from the KiK‐net sites has yet to be tested.
6 July 2021 in Bulletin of the Seismological Society of America
Soil nonlinear behavior is often triggered in soft sedimentary deposits subjected to strong ground shaking and has led to catastrophic damage to civil infrastructure in many past earthquakes. Nonlinear behavior in soils is associated with large shear strains, increased material damping ratio, and reduced stiffness. However, most investigations of the high‐frequency spectral decay parameter , which captures attenuation, have focused on low‐intensity ground motions inducing only small shear strains. Because studies of the applicability of the model when larger deformations are induced are limited, this article investigates the behavior of (both per record and site‐specific estimates) beyond the linear‐elastic regime. About 20 stations from the Kiban–Kyoshin network database, with time‐average shear‐wave velocities in the upper 30 m between 213 and , are used in this study. We find that the classification scheme used to identify ground motions that trigger soil nonlinear behavior biases estimates of in the linear and nonlinear regimes. A hybrid method to overcome such bias is proposed considering proxies for in situ deformation (via the shear‐strain index) and ground shaking intensity (via peak ground acceleration). Our findings show that soil nonlinearity affects and estimates, but this influence is station dependent. Most at our sites had a 5%–20% increase at the onset of soil nonlinear behavior. Velocity gradients and impedance contrasts influence the degree of soil nonlinearity and its effects on and . Moreover, we observe that other complexities in the wave propagation phenomenon (e.g., scattering and amplifications in the high‐frequency range) impose challenges to the application of the model, including the estimation of negative values of .
4 January 2023 in Bulletin of the Seismological Society of America
The 7.2 Nippes, Haiti, earthquake occurred on 14 August 2021 in Haiti’s southwest peninsula and in the midst of significant social, economic, and political crises. A hybrid reconnaissance mission (i.e., combined remote and field investigation) was coordinated to document damage to the built environment after the event. This article evaluates two ground‐motion records available in Haiti in the context of the geology of the region and known areas with significant damage, such as Les Cayes. We also present a new map of time‐averaged shear‐wave velocity values to 30 m depth ( ) for Les Cayes and Port‐au‐Prince based on the geostatistical approach of kriging and accounting for region‐specific geology proxies and field measurements of . Case studies of ground failure observations, including landslides and liquefaction triggering, are described as well as the intersection of social and engineering observations. Maps depicting this important intersection are provided to facilitate the assessment of how natural hazards and social conflicts have influenced the vulnerability of Haiti’s population to earthquakes.
Input motions used in seismic site response analyses are commonly selected based on similarities between the shear wave velocity ( VS ) at the recording station, and the reference depth at the site of interest (among other aspects such as the intensity of the expected ground motion). This traditional approach disregards the influence of the attenuation in the shallow crust on site response. Given that this attenuation (damping) can be characterized by the distance‐independent high‐frequency attenuation parameter κ0 , a VS‐κ0 correction framework for input motions is proposed to render them compatible with the assumed properties of the reference depth at the site. The proposed correction factors were applied to a subset of recordings from the KiK‐net database, and compared to traditional deconvolution. Results indicate that VS‐κ0 corrected motions outperform deconvolved motions in the characterization of the spectral energy in the high‐frequency range. However, motions recorded at sites with soft deposits are not good candidates for the VS‐κ0 correction approach. VS‐κ0 corrections also affect amplification functions which are important in the assessment of site‐specific seismic hazards.