Hydrothermal venting, an important cooling mechanism of the Earth, supports a diverse array of seafloor and sub-seafloor ecosystems that are sustained by large thermal and chemical fluxes. Vents have been found along even the slowest and coldest spreading centers, calling into question the driving heat source for these vents. The ultraslow-spreading Mid-Cayman Spreading Center in the Caribbean Sea, which hosts the axial-flank Von Damm Vent Field (VDVF), provides an opportunity to probe the mechanisms for venting at ultraslow spreading rates. Using active-source seismic data from the 2015 CaySeis (Cayman Seismic) experiment, we determined the seismic velocities in the large massif beneath the VDVF. We propose that this massif was produced by a pulse of on-axis magmatism at ca.2 Ma, which was then followed by exhumation, cooling, and fracturing. A low seismic velocity anomaly 5 km below the VDVF is evidence for either a cracking front mining lithospheric heat or intrusive magmatic sills, both of which could drive ongoing deep hydrothermal fluid circulation. We conclude that the transient magmatism and variable crustal thickness at ultraslow-spreading centers create conditions for long-lived hydrothermal venting that may be widespread, and other VDVF-like vents may be common in these areas.
1 November 2018 in Earth and Planetary Science Letters
We present results from a seismic refraction and wide‐angle experiment surveying an oceanic core complex on the Mid‐Atlantic Ridge at 22°19′N. Oceanic core complexes are settings where petrological sampling found exposed lower crustal and upper mantle rocks, exhumed by asymmetric crustal accretion involving detachment faulting at magmatically starved ridge sections. Tomographic inversion of our seismic data yielded lateral variations of P wave velocity within the upper 3 to 4 km of the lithosphere across the median valley. A joint modeling procedure of seismic P wave travel times and marine gravity field data was used to constrain crustal thickness variations and the structure of the uppermost mantle. A gradual increase of seismic velocities from the median valley to the east is connected to aging of the oceanic crust, while a rapid change of seismic velocities at the western ridge flank indicates profound differences in lithology between conjugated ridge flanks, caused by un‐roofing lower crust rocks. Under the core complex crust is approximately 40% thinner than in the median valley and under the conjugated eastern flank. Clear PmP reflections turning under the western ridge flank suggest the creation of a Moho boundary and hence continuous magmatic accretion during core complex formation.
Geophysical investigations of the northern Hikurangi subduction zone northeast of New Zealand, image fore‐arc and surrounding upper lithospheric structures. A seismic velocity (Vp) field is determined from seismic wide‐angle data, and our structural interpretation is supported by multichannel seismic reflection stratigraphy and gravity and magnetic modeling. We found that the subducting Hikurangi Plateau carries about 2 km of sediments above a 2 km mixed layer of volcaniclastics, limestone, and chert. The upper plateau crust is characterized by Vp = 4.9–6.7 km/s overlying the lower crust with Vp > 7.1 km/s. Gravity modeling yields a plateau thickness around 10 km. The reactivated Raukumara fore‐arc basin is >10 km deep, deposited on 5–10 km thick Australian crust. The fore‐arc mantle of Vp > 8 km/s appears unaffected by subduction hydration processes. The East Cape Ridge fore‐arc high is underlain by a 3.5 km deep strongly magnetic (3.3 A/m) high‐velocity zone, interpreted as part of the onshore Matakaoa volcanic allochthon and/or uplifted Raukumara Basin basement of probable oceanic crustal origin. Beneath the trench slope, we interpret low‐seismic‐velocity, high‐attenuation, low‐density fore‐arc material as accreted and recycled, suggesting that underplating and uplift destabilizes East Cape Ridge, triggering two‐sided mass wasting. Mass balance calculations indicate that the proposed accreted and recycled material represents 25–100% of all incoming sediment, and any remainder could be accounted for through erosion of older accreted material into surrounding basins. We suggest that continental mass flux into the mantle at subduction zones may be significantly overestimated because crustal underplating beneath fore‐arc highs have not properly been accounted for.