1 January 2018 in AIP Conference Proceedings
In the current work, we report the synthesis of Cobalt oxide (Co3O4) NPs (NPs) by co-precipitation method. The structural analysis was confirmed by using X-ray diffractometer (XRD) which shows that the Co3O4 NPs have cubic phase. The average crystallite size and the lattice parameter were calculated for Co3O4 NPs. The functional groups of the as-synthesized sample were examined by Fourier transform infrared spectroscopy (FTIR). The optical band gap of Co3O4 NPs was estimated by using UV diffuse reflectance spectroscopy and the Band gap was evaluated by using Tauc relation. The temperature dependence of dielectric constant and dielectric loss were studied over a range of temperature 50-300 °C. The DC electrical resistivity of Co3O4 NPs shows a semiconducting behaviour and the value of activation energy was calculated by using Arrhenius equation.
26 October 2018 in Journal of Applied Physics
In order to tailor the multiferroic as well as dielectric properties, we have synthesized BiFeO3 (BFO) and Ni-doped BFO nanoparticles of composition BiFe1-xNixO3 (0 ≤ x ≤ 0.07) via the sol-gel method. The influence of Ni-doping at the Fe site of BiFeO3 on the structural, dielectric, and multiferroic properties was investigated via various characterization techniques such as Raman spectroscopy, vibrating sample magnetometer, polarization-electric field (P-E) loop tracer, and LCR meter. The Raman spectra reveal the rhombohedral distorted perovskite structure of the samples in the R3c space group. The frequency dependent dielectric measurements at room temperature show that the dielectric constant for the pristine sample is an order of magnitude lower than the 1% Ni-doped BFO sample. It is also evident that the ac conductivity increases with the increase in frequency as well as Ni content. Further, the universal dielectric response (UDR) phenomenon is responsible for the dielectric behavior of all the samples in the whole frequency range except for the BiFeO3 and BiFe0.97Ni0.03O3 samples. These samples exhibit deviation from UDR phenomenon at higher frequencies. The room temperature hysteresis (M-H) loops exhibit the saturation in magnetization at higher magnetic fields. The result demonstrates a significant influence on the saturation magnetization with the Ni doping in BFO, prompting the ferromagnetic nature of the samples. The saturation magnetization of the 7% Ni-doped sample is approximately six times higher than the pristine one. The saturated P-E hysteresis loops establish the ferroelectric nature of the synthesized samples that are enhanced significantly on Ni doping. Thus, the doping of Ni in BiFeO3 improves the multiferroic properties of the matrix.
1 June 2018 in Materials Research Express
15 April 2020 in Journal of Materials Science: Materials in Electronics
27 July 2018 in Journal of Physics: Condensed Matter
In this report, Cu 2 O and Cu 2 O/rGO nanocomposites were successfully synthesized through chemical reduction method using glucose as a reducing agent for GO. The x-ray diffraction and field emission scanning electron microscope was used to investigate the phase composition and microstructure of the as-prepared materials. The presence of different functional groups in the as-synthesized sample was analyzed by Fourier transform infrared spectroscopy. Raman spectroscopy was used to confirm structural aspects such as defects of synthesized Cu 2 O/rGO nanocomposites. The optical properties of the as-prepared samples were analyzed by UV–vis diffuse reflectance spectroscopy and photoluminescence spectroscopy. Urbach energy is calculated in order to find out the defects in the nanocomposites. Zeta potential analysis was done to study the surface charge and stability of the as-synthesized samples. These results show that the content of rGO introduced into nanocomposite improves the optical properties of Cu 2 O thereby enhancing the utilization of visible light.
1 March 2018 in Materials Research Express