17 May 2010 in Estonian Journal of Engineering
A portable scattered light polariscope SCALP has been developed, which permits measurement of the residual stress profile through the thickness of glass panels. At a glass factory strength assessment of glass panels of different thermal treatment was carried out using both residual stress measurement with SCALP and the traditional four-point bending tests. Linear correlation between the residual surface stress and the bending strength was observed. At another glass factory residual stress in glass panels was measured before performing the traditional fragmentation test. The results of the fragmentation test were extremely scattered and had almost no correlation with the values of the residual stress. It is concluded that sufficiently reliable assessment of the strength of glass panels is obtained by measuring the residual stress at the surface.
22 March 2016 in Journal of Materials Science
21 February 2012 in Estonian Journal of Engineering
The paper shows that the residual stress at the surface of tempered glass panels may vary both locally (at a distance equal to the distance between the cooling jets) and globally, i.e., stresses near the edges and corners of the panels may be considerably different from the stresses in the middle part of the panels. That should be borne in mind while assessing the degree of temper by non-destructive measuring of the residual surface stress.
19 November 2019 in Journal of the American Ceramic Society
1 April 2019 in Journal of Non-Crystalline Solids
24 December 2015 in Journal of Applied Physics
A new optical method is presented for evaluation of the stress profile in chemically tempered (chemically strengthened) glass based on confocal detection of scattered laser beam. Theoretically, a lateral resolution of 0.2 μm and a depth resolution of 0.6 μm could be achieved by using a confocal microscope with high-NA immersion objective. The stress profile in the 250 μm thick surface layer of chemically tempered lithium aluminosilicate glass was measured with a high spatial resolution to illustrate the capability of the method. The confocal method is validated using transmission photoelastic and Na+ ion concentration profile measurement. Compositional influence on the stress-optic coefficient is calculated and discussed. Our method opens up new possibilities for three-dimensional scattered light tomography of mechanical imaging in birefringent materials.