1 September 2020 in Journal of Renewable and Sustainable Energy
Cross-flow turbines convert kinetic power in wind or water currents to mechanical power. Unlike axial-flow turbines, the influence of geometric parameters on turbine performance is not well-understood, in part because there are neither generalized analytical formulations nor inexpensive, accurate numerical models that describe their fluid dynamics. Here, we experimentally investigate the effect of aspect ratio—the ratio of the blade span to rotor diameter—on the performance of a straight-bladed cross-flow turbine in a water channel. To isolate the effect of aspect ratio, all other non-dimensional parameters are held constant, including the relative confinement, Froude number, and Reynolds number. The coefficient of performance is found to be invariant for the range of aspect ratios tested (0.95–1.63), which we ascribe to minimal blade–support interactions for this turbine design. Finally, a subset of experiments is repeated without controlling for the Froude number, and the coefficient of performance is found to increase, a consequence of the Froude number variation that could mistakenly be ascribed to aspect ratio. This highlights the importance of a rigorous experimental design when exploring the effect of geometric parameters on cross-flow turbine performance.
29 August 2024 in Renewable and Sustainable Energy Reviews
1 January 2025 in Journal of Renewable and Sustainable Energy
Cross-flow turbine (known as vertical-axis wind turbines or “VAWTs” in wind) blades encounter a relatively undisturbed inflow for the first half of each rotational cycle (“upstream sweep”) and then pass through their own wake for the latter half (“downstream sweep”). While most research on cross-flow turbine optimization focuses on the power-generating upstream sweep, we use single-bladed turbine experiments to show that the downstream sweep strongly affects time-averaged performance. We find that power generation from the upstream sweep continues to increase beyond the optimal tip-speed ratio. In contrast, the downstream sweep consumes power beyond the optimal tip-speed ratio due to unfavorable lift and drag directions relative to rotation and a potentially detrimental pitching moment arising from rotation-induced virtual camber. Downstream power degradation increases faster than upstream power generation, such that downstream sweep performance determines the optimal tip-speed ratio. In addition to performance measurements, particle image velocimetry data are obtained inside the turbine swept area at three tip-speed ratios. This illuminates the mechanisms underpinning the observed performance degradation in the downstream sweep and motivates an analytical model for a limiting case with high induction. Performance results are shown to be consistent across 55 unique combinations of chord-to-radius ratio, preset pitch angle, and Reynolds number, underscoring the general significance of the downstream sweep.
1 May 2025 in Journal of Renewable and Sustainable Energy
While confinement is understood to increase the power and thrust coefficients of cross-flow turbines, how the optimal rotor geometry changes with the blockage ratio—defined as the ratio between the array projected area and the channel cross-sectional area—has not been systematically explored. Here, the interplay between rotor geometry and the blockage ratio on turbine performance is investigated experimentally with an array of two identical cross-flow turbines at blockage ratios from 35% to 55%. Three geometric parameters are varied—the number of blades, the chord-to-radius ratio, and the preset pitch angle—resulting in 180 unique combinations of rotor geometry and blockage ratio. While the optimal chord-to-radius ratio and preset pitch angle do not depend on the blockage ratio, the optimal blade count increases with the blockage ratio—an inversion of the relationship between efficiency and blade count typically observed at lower blockage. To explore the combined effects of rotor geometry, rotation rate, and the blockage ratio on array performance, we utilize two bluff-body models: dynamic solidity (which relates thrust to the rotor geometry and kinematics) and Maskell-inspired linear momentum theory (which describes the array–channel interaction as a function of the blockage ratio and thrust). By combining these models, we demonstrate that the array time-average thrust coefficient increases with dynamic solidity in a manner that is self-similar across blockage ratios. Overall, these results highlight key design principles for cross-flow turbines in confined flow and provide insights into the similarities between the dynamics of cross-flow turbines and bluff bodies at high blockage.
19 August 2025 in Physical Review Fluids
1 May 2025 in JASA Express Letters
Radiated noise from marine energy harvesting is of environmental and engineering interest. Here, drifting hydrophones measure underwater noise in the vicinity of a relatively small wave energy converter. A statistical approach is demonstrated for attributing range-dependent, commonly occurring sounds in the frequency band from 90 to 600 Hz. Time-delay-of-arrival localization is then demonstrated for attribution of individual acoustic events likely associated with the power takeoff and wave-hull interactions. Because the radiated noise from the wave energy converter falls below ambient levels at a range of approximately 150 m, it is unlikely to substantially affect marine life at greater distance.