Aqueous solutions have attracted considerable attention for use in aqueous-based energy-conversion devices such as aqueous lithium-ion batteries. While aqueous solutions have some desirable properties as electrolyte solutions, one drawback is the narrow potential window of water due to the electrolysis reactions of water (oxygen/hydrogen evolution reaction, OER/HER). Recently, it has been reported that the potential windows were expanded in concentrated electrolyte solutions. In this study, we investigated the potential windows in aqueous concentrated electrolyte solutions with various salts at different concentrations. A neutral pH solution with the lowest water concentration showed the largest potential window, and the potential windows were not affected by the electrolyte salts. In addition, we observed an asymmetric expansion of potential windows: the upper potential limits were shifted more than the lower limits. This can be explained by the local pH change in the vicinity of electrodes caused by OER/HER and the decrease in the rate of OER due to the reduced water concentrations.
Depth-resolved X-ray absorption spectroscopy (DR-XAS) measurements were performed for the direct observation of the chemical state and local structure at the LiCoO2 electrode–solid electrolyte model interface, which can contribute towards the enhancement of the power density in all solid-state lithium batteries. The charge transfer resistance, measured by AC impedance spectroscopy, of the LiCoO2 electrode–solid electrolyte interface decreased with the introduction of a NbO2 interlayer at the interface, while the resistance increased with ZrO2 and MoO2 interlayers. Using DR-XAS with a depth resolution of about 7 nm, the changes in electronic structure and local structure of the LiCoO2 electrode were clarified. The extended X-ray absorption fine structure of DR-XAS revealed that the introduction of the NbO2 layer is effective for restricting the large Co–O bond change at the interface during delithiation. This interlayer relieved the stress at the interface due to the volume change of LiCoO2 during delithiation and then decreased the activation energy for the charge transfer process.