1 September 2012 in Construction and Building Materials
1 January 2012 in Procedia Engineering
This paper summarizes the results of experimental and numerical research focused on determination of the behavior and bond strength limits of what are currently the most widespread industrial glues used for anchor bonding. The goal of this research is to find the limits of the effective use of such glue types in high performance concrete, and also to verify the most commonly used design methods for bonded anchors. The progress and configuration of the experiments are described. The goal of this research is to find the limits of effective use of these glue types in high performance concrete and also verification of mostly used design methods. The article is closely focused on bond strength experiments using high strength concrete up to class C50/60 or higher
1 January 2012 in Procedia Engineering
Thin-walled cold formed corrugated steel sheet with embossments, used in composite steel concrete slab, is a modern and effective construction. The steel sheet is used as a permanent formwork and as a load bearing member after hardening of concrete as well. The prestressed embossments are crucial to ensure a composite action. However, its load bearing capacity is influenced by many factors and it is not possible to be determined without using expensive and time consuming tests of the whole slab in laboratory. This paper is focused on composite action using this type of shear connection and its behaviour under different types of loading.Four-point bending tests and vacuum tests were performed on the whole span slab. Additional small-scale shear test help us to understand the shear behaviour of thin-walled steel sheet in ultimate limit state. The data from the tests make possible to set up and calibrate numerical models. These models can then facilitate pointing out the main factors which influence the load bearing capacity of this type of structure
1 January 2017 in Procedia Engineering
7 August 2014 in Structural Concrete
2 November 2015 in IOP Conference Series: Materials Science and Engineering
The paper presents experimental and numerical research of strengthening of columns under load using welded plates. Three sets of three columns each were tested. All columns were 3 m long. The load from loading cylinders was transmitted through knife-edge bearings, which ensured pinned boundary condition perpendicular to the weaker axis. Set (A) comprised columns with welded T shaped cross-section. Set (B) comprised columns with welded monosymmetric I shaped cross-section. Both sets (A) and (B) had been loaded monotonically until collapse occurred. Set (C) contained columns with T shaped cross-section with the same dimensions as the columns in set (A). The columns from set (C) were first loaded to 70 kN. The force was being held constant and the second flange was being welded to the web under load. After the welding process was finished and the specimen cooled, the column was loaded to failure. The average forces at collapse of column sets (A), (B) and (C) were 143 kN, 308 kN and 323 kN, respectively. It was unexpected that the columns strengthened under load (C) had higher average resistance than the columns welded without preload (B). It could be caused by the residual stress and distortion caused by welding. The study includes the results of finite element models of the problem created in ANSYS software. The results from the experiments and numerical simulations were compared.