10 December 2019 in IEEE Transactions on Antennas and Propagation
In this communication, a novel dual-band dual-polarized filtering antenna with high selectivity is proposed. By etching four slots at each side of a square radiating patch, dual operation bands are observed as well as a natural radiation null between the two bands. Another two radiation nulls are generated by introducing a novel feeding structure, which is composed of a microstrip line with open-circuit stepped-impedance resonators (OCSIR). Thus, a dual-band bandpass filtering response of the realized gain is obtained. Each polarization of the antenna is differentially fed, and the differential port isolation is better than 37 dB. A prototype of the antenna element and a 1×4 array is fabricated and tested to validate our design. Measured results show that the antenna element has dual operation bands of 3.28-3.71 GHz and 4.8-5.18 GHz for VSWR<1.5. Besides, a high out-of-band gain-suppression level which reaches 17.7 dB is also obtained. Good performance of the proposed antenna makes it a promising candidate for 5G sub-6 GHz base station systems.
31 January 2024 in IEEE Transactions on Antennas and Propagation
A 5G base station antenna array with a frequency selective surface (FSS) radome is designed. The radome consists of a 1 mm thick metal layer and a 2.2 mm thick dielectric layer. The antenna array can effectively radiate within the operating frequency band and suppress out-of-band interference due to the utilization of FSS. More importantly, the metal layer of the FSS radome is in direct contact with a metal reflector, enabling efficient conduction of heat from the interior of the radome to the outside, thereby improving the base station’s heat dissipation capability. To validate the applicability of the designed heatsink radome in base station, a 1×4 base station antenna array is also designed. Simulation and measurement results demonstrate the antenna array with the radome achieves a working frequency band with a voltage standing wave ratio (VSWR) of less than 1.5, covering the range of 3.3 GHz to 3.8 GHz. The design also achieves a gain of 13.8 dBi ± 0.6 dBi, axial cross-polarization discrimination (XPD) greater than 20 dB, and XPD greater than 10 dB within ±60°. Compared to a pure dielectric radome, the proposed heatsink radome reduces the maximum temperature of the base station by 12.5 °C.
22 June 2020 in IEEE Antennas and Wireless Propagation Letters
This letter presents a dual-sense circularly polarized (CP) microstrip patch antenna with a dual-coupled line. The rectangular patch antenna operating in TM01 mode is utilized as a basic design, and a single-coupled line is introduced to excite the TM10 mode with a phase difference of 90°, generating CP operation. As different polarizations can be obtained by changing the position of the single-coupled line, a dual-coupled line is introduced to the rectangular patch antenna to excite two CP modes with different polarizations. The prototype of the dual-band dual-sense CP antenna is fabricated and measured. The measured results illustrate that the dual-sense CP antenna obtains a wide impedance bandwidth of 7.95% and dual axial ratio (AR) bandwidth of 0.33% for the left-hand circular polarization (LHCP) and 0.72% for the right-hand circular polarization (RHCP). Furthermore, the antenna has a wide 3 dB axial-ratio beamwidth and a small frequency ratio of 1.04.
19 December 2019 in IEEE Access
In this paper, a differentially fed, wideband dual-polarized patch antenna with filtering response is proposed. A novel E-shaped feeding structure with one end shorted to the ground is proposed to excite a square patch antenna, and an extra resonant mode is induced, which leads to a wider operation band. Besides, symmetric open/short-circuited stepped impedance resonators (O/SCSIRs) are proposed to generate the third resonant mode. And the bandwidth is further improved. Moreover, the gain-suppression level outside the operation bands is greatly enhanced as the introduction of O/SCSIRs. A prototype of the proposed antenna is fabricated and tested. Measured results show that the proposed antenna has a wide operation band of 22.2% (3.12-3.9 GHz) for active VSWR < 1.5. Stable in-band gains of 8.1 ± 0.3 dBi and unidirectional radiation patterns are also obtained. Moreover, the out-of-band gain suppression level is better than 18.5 dB. A 1×4 liner array is also developed to validate our design. Good radiating performance of the proposed antenna makes it a promising candidate for 5G Sub-6 GHz base station applications.
5 June 2019 in IEEE Access
In this paper, a wideband circularly polarized (CP) crossed-dipole antenna is presented by using parasitic modified patches. Four polygonal metal patches are sequentially rotated around the crossed dipoles. By tuning the electromagnetic coupling characteristic between the patches and the crossed dipoles, the axial-ratio bandwidth (ARBW) of the lower frequency band can be enhanced significantly. Furthermore, four slots are etched on the parasitic patches in a sequential rotation way, modifying the current distribution. Therefore, an extra CP mode produces at the higher band. A wide 3-dB axial-ratio bandwidth (ARBW) is realized by combing three CP modes, including the basic CP mode of the cross dipole at the middle frequency band. A prototype of the proposed broadband CP antenna was manufactured and measured to verify the design principle. The measurement results illustrate that the antenna has a wide 10-dB return loss bandwidth of 99.2% (1.24-3.68 GHz) and a broad 3-dB ARBW of 72.7% (1.41-3.02 GHz) for right-hand circular polarization (RHCP). Besides, stable gain and unidirectional radiation patterns are also obtained over the entire band of operation.
25 June 2019 in Microwave and Optical Technology Letters