8 May 2018 in Journal of Composite Materials
Thermal expansion, specific heat, diffusivity, and conductivity of carbon fiber-epoxy composites were studied using autoclave and out-of-autoclave prepregs with three different fabric weaves including unidirectional, eight-harness satin, and plain weave. For this purpose, light flash analysis was utilized where the implications of using anisotropic materials were studied. Results indicated that density, thermal expansion, conductivity, and diffusivity were strongly influenced by the fiber configuration of the sample. This phenomenon was attributed to the difference in fiber volume fraction induced by the different weaves of the fabric. Nevertheless, specific heat was similar for all the samples regardless of fabric type or resin formulation. Finally, thermal properties of tetrafluoroethylene release film were presented to analyze the tool-part heat transfer during manufacturing. This release film showed thermal conductivity three times lower than carbon fiber-epoxy samples indicating that the film could be an important contributor to thermal lag between tool and part.
1 July 2002 in Journal of Composite Materials
In Resin Transfer Molding (RTM), dry spot formation and air entrapment during the filling stage often lead to defective parts and high scrap rate. These problems are usually caused by improper design of inlet conditions and vent locations that prevent the Last Point to Fill (LPF) location from coinciding with the preset vent location. Use of direct filling simulation as a design tool for the RTM process often involves trial-and-error procedures in order to find the appropriate inlet conditions and locations as well as exit vent locations. This design procedure becomes complex when adesign involving multiple inlet gates is being considered, especially in large parts. There may also be uncertainty as to whether the final design (obtained using trial-and-error simulation procedures) is indeed the optimum design. This paper presents a methodology to design the RTM process with a desired filling pattern free of dry spots and knitlines. Unlike the traditional filling simulation that predicts the filling pattern using prescribed inlet conditions and the specification of the preform permeability field, this methodology calculates the optimum inlet conditions based on the specification of the desired filling pattern and the prescription of preform permeability. The use of this algorithm greatly enhances
12 December 2025 in Journal of Adhesion Science and Technology
24 November 2025 in Wind Engineering
A 3-D analysis of flow pattern and curing during VARTM manufacturing of a wind turbine blade is presented. The model was utilized in a case study to find the proper inlet arrangement that results in the shortest filling time. A sequential filling scheme was assumed, and different inlet gate arrangements and activation times were used in the study. It was observed that although increasing the number of inlet gates shortened the filling process, its effectiveness decreased monotonically. The observed filling issue was the presence of dry spots in the sandwich region at the bottom of the part. In the sandwich region, the core splits the flow into two flow fronts, one on the top and another at the bottom of the sandwich region. Case studies indicate that the slow-moving flow front beneath the core does not always merge with the faster-moving flow front on the top of the core.