1 August 2017 in Materials Science and Engineering: C
1 February 2018 in Ceramics International
1 April 2016 in Journal of the Mechanical Behavior of Biomedical Materials
1 May 2020 in Journal of Physics: Conference Series
In this work, aluminium nitride (AlN) single layer has been successfully grown on c-plane sapphire using metalorganic chemical vapor deposition (MOCVD) at low reactor pressure. The effects of growth temperature, ammonia (NH3) flux and trimethylaluminum (TMAl) flux towards AlN growth were investigated. It was noted that the reaction between NH3 and TMAl has affected the growth rate across the growth temperature. Field emission scanning electron microscopy (FESEM) equipped with Energy-dispersive X-ray (EDX) have revealed the formation of AlN single layer on the sapphire substrate and elemental composition of the layer, respectively. The dependence of growth rate on growth temperature, TMAl flux and NH3 flux has been observed. A relationship was drawn, whereby an increase in TMAl flux and decrease in NH3 flux would lead to an increase in the AlN growth. In addition, a drastic increase in the AlN growth was observed at high growth temperature, which was more than 1100°C. Furthermore, observation from atomic force microscopy (AFM) indicated improvement on surface roughness as growth rate increases. Further characterization was carried out using phase analysis using high resolution X-ray diffraction (HRXRD).
1 May 2020 in Journal of Physics: Conference Series
This work demonstrated the effect of post-annealing on electrical and optical characteristics of indium tin oxide (ITO) thin films. ITO with 100 nm thickness was successfully deposited using radio frequency (RF) magnetron sputtering in oxygen-free environment on sodalime glass substrate without substrate heating. Post-annealing treatment was carried out on ITO thin films in oxygen environment. Different annealing temperatures were studied on the films from 300°C up to 600 °C. The annealing time and oxygen flow rate were kept constant. As the annealing temperature increase, the structure of the thin film’s changes from amorphous to polycrystalline which lead to the effect of enhanced hall mobility. Annealing temperature strongly influence the optical transmission in visible region. It leads to higher transmittance of ITO thin films and is suitable for a blue light emitting diode (LED) application. In addition, higher annealing temperature also enhances film electrical performance. Further characterization of the deposited films was done using hall measurement, UV-Vis spectrophotometer and atomic force microscopic (AFM) to show the improvement on their electrical and optical characteristic. The optical and electrical characteristics of the films have been compared with each other.