On 15 January 2022, the Hunga Tonga-Hunga Ha‘apai volcano erupted, producing tsunamis worldwide including first waves which arrived more than 2 hours earlier than what is expected for conventional tsunamis. We investigated the generation and propagation mechanisms of the tsunami “forerunner,” and our simulation found that fast-moving atmospheric Lamb waves drove the leading sea height rise whereas the scattering of the leading waves related to bathymetric variations in the Pacific Ocean produced subsequent long-lasting tsunamis. Tsunamis arriving later than the conventionally expected travel time are composed of various waves generated from both moving and static sources, which makes the tsunami, due to this eruption, much more complex and longer-lasting than ordinary earthquake-induced tsunamis.
In southwest Japan, great earthquakes have occurred on the plate interface along the Nankai trough with a recurrence time of approximately 100 years. Most previous studies estimated slip deficits on the seismogenic zone from interseismic Global Navigation Satellite System (GNSS) velocity data assuming slip‐response functions for an elastic medium. The observed surface velocities, however, include effects of viscoelastic relaxation in the asthenosphere caused by slip motion associated with seismic cycles. If the elastic responses cannot adequately approximate the deformation of the viscoelastic medium, the results of an inversion analysis could be biased. If the recurrence interval is greater than the effective relaxation time in the elastic‐viscoelastic layered structure, we were able to formulate an inverse problem for the estimation of slip‐deficit rates from GNSS velocity data with completely relaxed slip‐response functions for a later stage of the seismic cycle. Analyzing surface velocity data from GNSS daily coordinate data between March 2005 and February 2011 together with seafloor geodetic data, we estimated the slip‐deficit rate distribution by the strain data inversion method. There were significant differences between the results using elastic and completely relaxed responses. Although the result with elastic responses shows a high coupling zone in the coastal region, it was located trenchward when completely relaxed responses were used. We found that the peak slip‐deficit rate increases as the thickness of the lithosphere becomes thinner. Moreover, we succeeded in appropriately separating elastic‐viscoelastic deformation due to plate coupling from rigid block motion.
21 July 2014 in Journal of Geophysical Research: Oceans
This study reveals the roles of the wave dispersion and nonlinear effects for the 2011 Tohoku‐Oki earthquake tsunami. We conducted tsunami simulations based on the nonlinear dispersive equations with a high‐resolution source model. The simulations successfully reproduced the waveforms recorded in the offshore, deep sea, and focal areas. The calculated inundation area coincided well with the actual inundation for the Sendai Plain, which was the widest inundation area during this event. By conducting sets of simulations with different tsunami equations, we obtained the followings insights into the wave dispersion, nonlinear effects, and energy dissipation for this event. Although the wave dispersion was neglected in most studies, the maximum amplitude was significantly overestimated in the deep sea if the dispersion was not included. The waveform observed at the station with the largest tsunami height (∼2 m) among the deep‐ocean stations also verified the necessity of the dispersion. It is well known that the nonlinear effects play an important role for the propagation of a tsunami into bays and harbors. Additionally, nonlinear effects need to be considered to accurately model later waves, even for offshore stations. In particular, including nonlinear terms rather than the inundation was more important when precisely modeling the waves reflected from the coast.