Theresa Grünleitner

Theresa Grünleitner

Auto-generated profile, based on publicly available information

Theresa Grünleitner

Walter Schottky Institute and Physics Department Technical University of Munich 85748 Garching Germany

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 December 2022 in ACS Nano
Verified
Journal Article
Closed access
TGTheresa Grünleitner
Theresa Grünleitner
AHAlex Henning
Alex Henning
MBMichele Bissolo
Michele Bissolo
MZMarisa Zengerle
Marisa Zengerle
LGLuca Gregoratti
Luca Gregoratti
ISIan D. Sharp
Ian D. Sharp

18 April 2023 in Advanced Materials Interfaces
Verified
Journal Article
Open access
AHAlex Henning
Alex Henning
SLSergej Levashov
Sergej Levashov
CQChenjiang Qian
Chenjiang Qian
TGTheresa Grünleitner
Theresa Grünleitner
JPJulian Primbs
Julian Primbs
ISIan D. Sharp
Ian D. Sharp
Here, it is shown that in situ spectroscopic ellipsometry (SE) is a powerful method for probing the effects of reactant adsorption and film formation on the excitonic properties of 2D materials during atomic layer deposition (ALD), thus allowing optimization of both film growth and opto(electronic) characteristics in real time. Facilitated by in situ SE during ALD on monolayer MoS2, a low temperature (40 °C) process for encapsulation of the 2D material with a nanometer‐thin alumina (AlOx) layer is investigated, which results in a 2D/3D interface governed by van der Waals interactions rather than chemical bonding. Charge transfer doping of MoS2 by AlOx is found to be an interfacial phenomenon that initiates from the earliest stages of film formation, but saturates upon deposition of a closed layer. However, the lack of chemical binding interactions at the 2D/3D interface enables physical removal of the AlOx that results in a reversal of the charge transfer doping effect. Overall, it is demonstrated that in situ SE of 2D materials during ALD can precisely probe the impact of film formation on sensitive optoelectronic characteristics of 2D materials, which is of key importance in the development of integrated 2D/3D systems.

16 December 2022 in Advanced Materials Interfaces
Verified
Journal Article
Open access
AHAlex Henning
Alex Henning
JBJohannes D. Bartl
Johannes D. Bartl
LWLukas Wolz
Lukas Wolz
MCMaximilian Christis
Maximilian Christis
FRFelix Rauh
Felix Rauh
ISIan D. Sharp
Ian D. Sharp
Atomic layer deposition (ALD) is a key technique for the continued scaling of semiconductor devices, which increasingly relies on scalable processes for interface manipulation of structured surfaces on the atomic level. While ALD allows the synthesis of conformal films with utmost control over the thickness, atomically‐defined closed coatings and surface modifications are challenging to achieve because of 3D growth during nucleation. Here, a route is presented toward the sub‐nanometer thin and continuous aluminum oxide (AlOx) coatings on silicon substrates for the spatial control of the surface charge density and interface energetics. Trimethylaluminum in combination with remote hydrogen plasma is used instead of a gas‐phase oxidant for the transformation of silicon dioxide (SiO2) into alumina. Depending on the number of ALD cycles, the SiO2 can be partially or fully transformed, which is exploited to deposit ultrathin AlOx layers in selected regions defined by lithographic patterning. The resulting patterned surfaces are characterized by lateral AlOx/SiO2 interfaces possessing 0.3 nm step heights and surface potential steps exceeding 0.4 V. In addition, the introduction of fixed negative charges of 9 × 1012 cm−2 enables modulation of the surface band bending, which is relevant to the field‐effect passivation of silicon and low‐impedance charge transfer across contact interfaces.

22 January 2022 in Advanced Functional Materials
Verified
Journal Article
Open access
PDF file
TGTheresa Grünleitner
Theresa Grünleitner
AHAlex Henning
Alex Henning
MBMichele Bissolo
Michele Bissolo
AKArmin Kleibert
Armin Kleibert
CVCarlos A.F. Vaz
Carlos A.F. Vaz
ISIan D. Sharp
Ian D. Sharp
A novel transparent conductive support structure for scalable integration of 2D materials is demonstrated, providing an electronically passive 2D–3D interface while also enabling facile interfacial charge transport. This structure, which comprises an evaporated nanocrystalline carbon (nc‐C) film beneath nanometer‐thin atomic layer deposited AlOx, is thermally stable and allows direct chemical vapor deposition of 2D materials onto the surface. The combination of spatial uniformity, enhanced charge screening, and low interface defect concentrations yields a tenfold enhancement of MoS2 photoluminescence intensity compared to flakes on conventional Si/SiO2, while also retaining the strong optical contrast for monolayer flakes. Tunneling across the ultrathin AlOx enables facile interfacial charge injection, which is utilized for high‐resolution scanning electron microscopy and photoemission electron microscopy with no detectable charging. Thus, this combination of scalable fabrication and electronic conductivity across a weakly interacting 2D–3D interface opens up new opportunities for device integration and characterization of 2D materials.