PETROBRAS is conducting a research project with the purpose of investigating the behavior of pipeline with long nonuniform corrosion defects. In the first phase of this project, burst tests of two tubular specimens were carried out. Each of the two specimens had one external nonuniform depth corrosion defect, machined using spark erosion. The specimens were cut from longitudinal welded tubes made of API 5L X60 steel with an outside diameter of 323.9 mm and a nominal wall thickness of 9.53 mm. Each of the two tubular specimens was instrumented with 17 post-yield strain gages rosettes, one displacement transducer and two pressure transducers. This paper describes the tubular specimens tested and the instrumentation used. The measured burst pressures are compared with those predicted by the ASME B31G and the RSTRENG Effective Area methods. The material properties used were determined by tests of tensile specimens. Photographs of the fractured defects are presented along with comments about their differences in shape. Some values of strain measured during the tests are also presented and commented.
PETROBRAS is conducting a research project with the purpose of investigating the behavior of pipelines with long corrosion defects. In the first phase of this project a database containing the results of nine burst tests of tubular specimens with flat bottom defects was generated. The second phase of the project aims at appraising the performance of two different finite element models: a shell model and a solid model. This paper describes the application of these models in the analysis of four tubular specimens of the PETROBRAS database. The failure pressures predicted by the two types of finite element models are compared with the burst pressures measured in the laboratory tests. Also a comparison between the results obtained by these models is presented. It is concluded that the solid model is more accurate than the shell model, but both models proved to be capable of simulating the corroded pipe burst tests adequately.
The residual fatigue life of a corroded riser joint can be evaluated by means of a fatigue analysis based on S-N data. In this case nominal stresses are determined through a global riser analysis in which the drilling riser is modeled as a tensioned beam subjected to loads throughout its length and with boundary conditions at each end. The effect of the corrosion defects is taken into account multiplying the nominal stresses by stress concentration factors (SCFs) derived by local Finite Element (FE) analyses of the riser joints containing corrosion defects. In this paper stress concentration factors for a drilling riser containing corrosion pits are calculated using solid FE models. These pits are situated on the external surface of the riser joints. Three shapes of corrosion pits are considered: semi spherical, cylindrical wide and cylindrical narrow. Five depths of corrosion pits are considered: 12.6%, 20.1%, 30.2%, 40.3% and 50.3% of the riser wall thickness. The riser outside diameter and the riser wall thickness are 533.4 mm (21 in) and 15.9 mm (0.625 in), respectively.
1 December 2020 in Rio Oil and Gas Expo and Conference