Monitoring microbial electrochemical processes in a time-and cost-efficient manner requires multi-channel potentiostats with the capability to control each channel towards a unique targeted potential. State-of-the-art (SotA) PCB potentiostats cannot perform high-frequency analysis due to their limited bandwidth. Existing integrated CMOS potentiostats on the other hand enable higher sensing channel density with a high bandwidth, yet are still limited in the number of parallel stimulation channels. The presented 40nm CMOS potentiostat chip overcomes this bottleneck with 96 individually controllable stimulation and sensing channels with a wide 12 pA $-$ 137 $\mu$ A current range and up to 3 MHz bandwidth. The architecture is optimized for area-efficiency and includes a digital feedback controller integrated on-chip, supporting multi-functional electrochemical analysis techniques. Fully parallel operation is demonstrated for a (bio-)electrochemical measurement.
5 March 2019 in IEEE Transactions on Instrumentation and Measurement
Electrochemical experiments like chronoamperometry or cyclic voltammetry (CV) are essential in the research for novel bioelectrochemical systems. These experiments, executed by a potentiostat, are time-consuming which hinders research progression. To speed up those experiments, this work presents a potentiostat with 128 individual parallel stimulation and sensing channels. A channel architecture exploiting time division multiplexing is developed to minimize the hardware cost and area. Potential control is done in the digital domain using 128 individual Linear Quadratic Integral (LQI) controllers. The 128-channel potentiostat is implemented with Printed Circuit Board (PCB) technology and has $16 {\times }$ more channels than the state of the art low-cost potentiostats with a $4 {\times }$ lower cost-per-channel (5 $) and a $4 {\times }$ lower area-per-channel (${93}\,mm^{2}$ ). Using parallelism, chronoamperometry experiments can be done ${128\times }$ faster, while a conventional ${1}\, mV\,s^{-1}$ -CV can be done $72\,\, {\times }$ faster by sampling instead of voltage sweeping.